Yamaha RX-V379 Owner's Manual download pdf (Page 61)

En 61

Refer to the table below when the unit does not function properly.

If the problem you are experiencing is not listed below or if the instructions below do not help, turn off the unit, disconnect the power cable, and contact the nearest authorized

Yamaha dealer or service center.

First, check the following:

The power cables of the unit, TV and playback devices (such as

DVD

players) are connected to AC wall outlets securely.

b The unit, subwoofer, TV and playback devices (such as BD/DVD players) are turned on.

c The connectors of each cable are securely inserted in to jacks on each device.

Power, system and remote control

Troubleshooting

Problem Cause Remedy

The power does not turn on.

The protection circuitry has been activated three times

consecutively.

As a safety precaution, capability to turn on the power is disabled. Contact your

nearest Yamaha dealer or service center to request repair.

The power does not turn off.

The internal microcomputer has frozen, due to an external electric

shock (such as lightning or excessive static electricity) or to a drop

in the power supply voltage.

Hold down z (power) on the front panel for more than 15 seconds to reboot the

unit. (If the problem persists, disconnect the power cable from the AC wall outlet

and plug it again.)

The power turns off (standby mode) immediately. The unit was turned on while a speaker cable was shorted.

Twist the bare wires of each speaker cable firmly and reconnect to the unit and

speakers (p.15).

The unit enters standby mode automatically.

The sleep timer worked. Turn on the unit and start playback again.

The auto-standby function kicked in because the unit was not used

for the specified time.

To disable the auto-standby function, set “Auto Power Standby” in the “Setup”

menu to “Off” (p.54).

The speaker impedance setting is incorrect. Set the speaker impedance to match your speakers (p.57).

The protection circuitry has been activated because of a short

circuit.

Twist the bare wires of each speaker cable firmly and reconnect to the unit and

speakers (p.15).

The unit is not reacting.

The internal microcomputer is frozen, due to an external electric

shock (such as lightning or excessive static electricity) or to a drop

in the power supply voltage.

Hold down z (power) on the front panel for more than 15 seconds to reboot the

unit. (If the problem persists, disconnect the power cable from the AC wall outlet

and plug it again.)

The unit cannot be controlled using the remote

control.

The unit is out of the operating range. Use the remote control within the operating range (p.4).

The batteries are weak. Replace with new batteries.

The unit’s remote control sensor is exposed to direct sunlight or

strong lighting.

Adjust the lighting angle, or reposition the unit.

The remote control IDs of the unit and the remote control are not identical.

Change the remote control ID of the unit or the remote control (p.58).

Cannot select the desired input source even if

"INPUT" is pressed.

The function which skips some input sources is set. Set "Input Skip" of the desired input source in the "Setup" menu to "Off" (p.55).

00_RX-V379_om_U.book Page 61 Tuesday, January 13, 2015 4:50 PM

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 77 78

Comments to this Manuals

No comments

Yamaha RX-V379 Owner's Manual Page 61

Comments to this Manuals

Related products and manuals for AV receivers Yamaha RX-V379