Yamaha RX-V2065 Manual download pdf (Page 55)

53 En

Operating various settings for this unit (Setup menu)

English

INTRODUCTION

ADDITIONAL

INFORMATION APPENDIX

PREPARATION

BASIC

OPERATION

ADVANCED

OPERATION

MAC Address 1-10

Specify MAC addresses of network devices that are

permitted to access to this unit when “MAC Address

Filter” is set to “On”.

■ Network Standby

Selects whether or not to accept the commands via

network when this unit is on standby.

• When “Network Standby” is set to “On”, the amount of power

consumption in the standby mode increases.

■ Information

Displays the network parameters (IP address, etc.) or

vTuner ID assigned to this unit.

Although the field sound programs would satisfy you as

they are with the default parameters, you can arrange

sound effect or decoders suitable for acoustical conditions

of sources or rooms by setting the parameters.

1 Press jCursor k / n to select “DSP

Parameter” and then press jENTER.

2 Press jCursor k / n to select “Program

Name” and then press jCursor l / h to

select a sound field program to edit.

3 Press jCursor k / n to select a parameter to

edit and then press jCursor l / h to

change the setting.

• Repeat steps 2 and 3 to change other sound field program

parameters.

DSP Level

Fine adjusts an effect level (level of the sound field effect

to be added). You can adjust the level of the sound field

effect while checking sound levels. Adjust “DSP Level” as

follows.

• The effect sound is too soft.

• There are no differences between effects of the sound

field programs.

→Increase the effect level.

• The sound is dull.

• The sound field effect is added too much.

→Reduce the effect level.

On Permit access to this unit only from network

devices with the specified MAC addresses.

Choices: Off*, On

Off Not accept the commands via network.

On Accept the commands via network.

DSP Parameter

To initialize the parameters of the selected sound field

program, press jCursor n repeatedly to select

“Initialize” and then press jCursor h. Then, press

jCursor h again to execute the initialization or

jCursor l to cancel it.

CINEMA DSP basic parameters

Adjustable range: –6dB to 0dB* to +3dB

Sci-Fi

PLIIx Movie

0dB

16ms

1.0

2ms

1.0

DSP Parameter

Program Name

Decode Type

DSP Level

P. Initial Delay

P. Room Size

Sur. Initial Delay

Sur. Room Size

Sound field parameters Set values

Sound field program

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 175 176

Comments to this Manuals

No comments

Yamaha RX-V2065 Manual Page 55

Comments to this Manuals

Related products and manuals for AV receivers Yamaha RX-V2065