En 119
■ System
Displays the system information on the unit.
• If the unit detects a newer firmware over the network, “!” (exclamation mark) appears at the upper right of
the “Information” and “System” icons, and the corresponding message will be displayed in this screen. You
can update the unit’s firmware by pressing ENTER in this screen and following the procedure in “Updating
the unit’s firmware via the network” (p.123).
■ Multi Zone
Displays information about Zone2.
Configure the system settings of the unit while viewing the front display.
1
Set the unit to standby mode.
2
While holding down STRAIGHT on the front panel, press MAIN ZONE
z
.
3
Press PROGRAM to select an item.
4
Press STRAIGHT to select a setting.
5
Press MAIN ZONE
z
to set the unit to standby mode and turn it on again.
The new settings take effect.
ADVANCED SETUP menu items
• Default settings are underlined.
Remote ID The unit’s remote control ID setting (p.120)
TV Format The unit’s video signal type (p.120)
Speaker Impedance The speaker impedance setting of the unit (p.120)
Tuner Freq. Step
(Asia and General models only)
The FM/AM tuning frequency setting of the unit (p.120)
System ID System ID number
Firmware Version The version of firmware installed on the unit
Input The input source selected for Zone2
Volume The volume setting for Zone2
Configuring the system settings
(ADVANCED SETUP menu)
Item Function Page
SP IMP. Changes the speaker impedance setting. 120
REMOTE ID Selects the unit’s remote control ID. 120
TU
(Asia and General models only)
Changes the FM/AM tuning frequency setting.
120
TV FORMAT Switches the video signal type. 120
MON.CHK Removes the limitation on HDMI video output. 121
4K MODE Selects the HDMI 4K signal format. 121
INIT Restores the default settings. 121
MAIN ZONE z
STRAIGHTPROGRAM
(RX-A850)
MAIN ZONE z
STRAIGHTPROGRAM
(RX-A750)
Comments to this Manuals