Yamaha RX-A1020 Owner's Manual Page 104

  • Download
  • Add to my manuals
  • Print
  • Page
    / 150
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 103
CONFIGURATIONS Configuring various functions (Setup menu) En 104
Adjustment
Adjusts the delay between video and audio output manually when “Auto/Manual
Select” is set to “Manual”. You can fine-adjust the audio output timing when
“Auto/Manual Select” is set to “Auto”.
Setting range
0 ms to 500 ms (1 ms increments)
Default
0 ms
“Offset” shows the difference between automatic adjustment and fine adjustment.
Dynamic Range
Selects the dynamic range adjustment method for bitstream audio (Dolby Digital and
DTS signals) playback.
Settings
Max Volume
Sets the maximum volume to prevent excessive loudness.
Setting range
-30.0 dB to +15.0 dB (5.0 dB increments), +16.5 dB
Default
+16.5 dB
Initial Volume
Sets the initial volume when the receiver is turned on.
Settings
Pure Direct Mode
Selects whether to output video signals during the Pure Direct mode (p.55).
Settings
Adaptive DSP Level
Selects whether to automatically adjust the CINEMA DSP effect level.
Settings
Maximum (default) Produces audio without adjusting the dynamic range.
Standard Optimizes the dynamic range for regular home use.
Minimum/Auto
Sets the dynamic range for clear sound even at night or at low
volumes.
When playing back Dolby TrueHD signals, the dynamic range is
automatically adjusted based on the input signal information.
Off (default)
Sets the level to the volume level of the unit when it last entered
standby mode.
On
Sets at Mute or the specified volume level (-80 dB to +16.5 dB, 0.5 dB
increments).
(This setting works only when the initial volume is set lower than “Max
Volume.)
Auto (default)
Automatically outputs video signals when any videos are input from
the selected input source or an input source that can be operated with
the on-screen display is selected. When no video signals are input,
the wall paper is displayed.
Video Off Does not output video signals including the wall paper.
Off Does not adjust the effect level automatically.
On (default)
Adjusts the effect level automatically according to the YPAO
measurement results and the volume level.
Page view 103
1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 149 150

Comments to this Manuals

No comments