Yamaha HTR-6230 Owner's Manual download pdf (Page 46)

44 En

Troubleshooting

After AUTO SETUP

Notes

• If the “ERROR” or “WARNING” screens appears, check the cause of the problem, then run “AUTO SETUP” again.

• If a warning message “PHASE REVERSED” appears, corrections are made, but they may not be optimal.

• If a warning message “DISTANCE ERROR” or “LEVEL ERROR” appears, no corrections are made.

■ Remote control

■ Resetting the system

Use this feature to reset all the parameters of this unit to the initial factory settings. For details about the procedure of

resetting the system, see “Initializing” in “Advanced setup” on page 39.

Warning message Cause Remedy

See

page

PHASE REVERSED Speaker polarity is not correct. This

message may appear depending on the

speakers even when the speakers are

connected correctly.

Check the speaker connections for proper polarity (+

or –).

DISTANCE ERROR The distance between the nearest speaker

and the furthest speaker is out of

adjustable range.

Bring the speaker closer to the listening position. —

LEVEL ERROR The difference of volume level among

speakers is excessive. (No level correction

is made.)

If “SWFR:TOO LOUD” or “SWFR:TOO LOW”

appears, adjust the output volume of the subwoofer.

Readjust the speaker installation so that all speakers

are set in locations with similar conditions.

—

Check the speaker connections. 9

Use speakers of similar quality. —

Problem Cause Remedy

See

page

The remote control

does not work nor

function properly.

Wrong distance or angle. The remote control functions within a maximum

range of 6 m (20 ft) and no more than 30 degrees off-

axis from the front panel.

Direct sunlight or lighting (from an

inverter type of fluorescent lamp, etc.) is

striking the remote control sensor of this

unit.

Reposition this unit. —

The batteries are weak. Replace all batteries. 8

The remote control code is not correctly

set.

Set the remote control code correctly using “List of

remote control codes” at the end of this manual.

Try setting another code for the same manufacturer

using “List of remote control codes” at the end of this

manual.

Even if the remote control code is

correctly set, there are some models that

do not respond to the remote control.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 55 56

Comments to this Manuals

No comments

Yamaha HTR-6230 Owner's Manual Page 46

Comments to this Manuals

Related products and manuals for AV receivers Yamaha HTR-6230