Yamaha HTR-4063 Quick Start Guide download pdf (Page 3)

- 3 -

Caution:

Remove the AC power cord of this unit from the power outlet •

before connecting the speakers.

Generally speaker cables consist of two parallel insulated •

cables. One of these cables is a different color, or has a

line running along it, to indicate different polarity. Insert the

different colored (or lined) cable into the “+” (positive, red)

terminal on this unit and the speakers, and the other cable into

the “-” (minus, black) terminal.

Be careful that the core of the speaker cable does not touch •

anything or come into contact with the metal areas of this

unit. This may damage this unit or the speakers. If the speaker

cables short circuit, “CHECK SP WIRES!” will appear on the

front panel display when this unit is switched on.

(U.S.A. and Canada models only) When connecting 6 Ω •

speakers, set the speaker impedance to 6 Ω on this unit before

making connections. Refer to Owner’s Manual for information

on settings.

Connect the speakers

Connecting the speakers

Remove approximately 10 mm of insulation from

the ends of the speaker cables, and twist the bare

wires of the cables together  rmly so that they will

not cause short circuits.

Loosen the speaker terminals.

Insert the bare wire of the speaker cable into the

gap on the side of the terminal.

Tighten the terminal.

CENTER

SURROUND

HDMI 3

HDMI 4

FRONT

AUDIO

OUT

SPEAKERS

PRE OUT

SUBWOOFER

SINGLE

SURROUND BACK

Front speaker

R L

Surround speaker

R L

SubwooferCenter speaker

Connecting the subwoofer

Connect the subwoofer input jack to the SUBWOOFER

jack on this unit with an audio pin cable.

Set the subwoofer volume as follows.

Volume: Set to approximately half volume (or slightly less than

half).

Crossover frequency (if available): Set to maximum.

Subwoofer examples

VOLUME

MIN MAX

CROSSOVER/

HIGH CUT

MIN MAX

When using the 7.1/6.1-channel surround

system

Connecting an external ampli er to the SURROUND

BACK L/R jacks of the PRE OUT terminals allows you

to create the maximum of 7.1-channel surround system

with a surround back channel.

Refer to the Owner’s Manual for information on how to

connect the surround back speakers.

Connecting the banana plug

(Except U.K., Europe, Asia and Korea

models)

Tighten the knob, and then insert the banana plug

into the end of the terminal.

Banana plug

FRO

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Yamaha HTR-4063 Quick Start Guide Page 3

Comments to this Manuals

Related products and manuals for AV receivers Yamaha HTR-4063