Yamaha 006IPTO-F0 User Manual download pdf (Page 150)

150 Chapter 12—Grouping Channels & Linking Parameters

DM1000 Version 2—Owner’s Manual

7To use a mute group, press one of the [ON] buttons for the grouped channels.

All channels in the group switch their on/off status.

Using Fader Group Master

The DM1000 features a Fader Group Master function that enables you to control the level of

all channels using the Group Master level while maintaining the relative balance between

channels, much like a VCA group on an analog mixing console. While this function is enabled,

channel fader operation does not affect channel levels in the corresponding Fader group.

1 After you perform Step 5 in “Using Fader Groups and Mute Groups” on

page 148, use the cursor buttons to select the INPUT FADER MASTER check

box or the OUTPUT FADER MASTER check box, then press [ENTER] to turn

on the Fader Group Master function.

2 When the Fader Master check box is checked, you can set channel levels of

the Fader groups in the Master column.

When the Master column is selected, repeatedly pressing the [ENTER] button turns the

Fader group on and off.

You can also make these settings in the In Master page or Out Master page, as shown below.

3 Press the DISPLAY ACCESS [GROUP] button repeatedly until the Group | In

Master or Group | Out Master page appears.

Note:

• While a mute group is enabled, you cannot turn a subset of the grouped channels on or off.

•If you wish to turn a subset of the grouped channels on or off, ﬁrst turn off the Enable button,

or remove the channels you wish to turn on or off from the group.

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 387 388

No comments

Yamaha 006IPTO-F0 User Manual Page 150