Yamaha 02R96 Owner's Manual download pdf (Page 195)

182 Chapter 18—Pro Tools Remote Layer

02R96—Owner’s Manual

Assigning Inserts/Plug-ins

Inserts can be assigned to channels as follows. The Pro Tools transport must be stopped in

order to make these assignments.

1 Press the EFFECTS PLUG-INS [CHANNEL INSERTS] button.

Its indicator lights up and the [SEL] buttons are set to Insert Select mode.

2 Use the [SEL] buttons to select channels for insert assignment.

The name of the selected channel appears in the INSERT/PARAM section of the display.

The border of the corresponding channel name in the Pro Tools Mix window is highlighted

red.

3 Press the EFFECTS/PLUG-INS [1] (ASSIGN) button.

Its indicator ﬂashes, as does the ASSIGN indicator on the display.

4 Use Parameter controls 1–4 to select inserts/plug-ins.

The names of the inserts/plug-ins appear on the display in abbreviated form. When you

select an insert/plug-in other than the current, the corresponding SEL button ﬂashes on the

display.

5 To conﬁrm your selection, press the relevant Parameter control’s

push-switch.

The SEL button stops ﬂashing.

While the EFFECTS/PLUG-INS [1] (ASSIGN) button indicator is still ﬂashing, you can

assign more inserts/plug-ins to the same channel. To set insert #5, press the Parameter

Down (SCROLL >) button. Press the Parameter Up (< SCROLL) button to view inserts 1–4

again.

To assign inserts/plug-ins to other channels, use the [SEL] buttons to select them. You’ll

need to press the EFFECTS/PLUG-INS [1] (ASSIGN) button each time you select another

channel.

You can cancel this function by pressing the [DEC] (ESC) button.

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 314 315

No comments

Yamaha 02R96 Owner's Manual Page 195