Yamaha TX6n Owner's Manual download pdf (Page 8)

TX6n/5n/4n Owner’s Manual

Firmware Updates

The ﬁrmware version of the TXn itself can be checked from the TXn’s panel and from Amp Editor. You can

update the ﬁrmware via Amp Editor. For the update procedure, refer to the Amp Editor Owner’s Manual.

You can download the latest ﬁrmware from the “Downloads” page on the following website.

http://www.yamahaproaudio.com/

Preparation

• Be sure to turn all devices OFF before connecting

AC mains power.

Insert the plug into an AC outlet. Be sure to use an AC outlet

of the voltage speciﬁed for the device.

•To prevent the initial power-on surge from gener-

ating a large noise spike or damaging your

speaker system, turn the devices on in the follow-

ing order: audio sources, mixer (such as M7CL or

PM5D), and ﬁnally power ampliﬁers. Reverse this

order when turning power off.

Press the front panel [POWER] switch to the

“ON” position to turn the power on.

Press the [POWER] switch to the “OFF” position

to turn off the power.

• The settings at the time you powered-off are

remembered. When you turn on the power to the

TXn, it will start up with the same settings. You

can use the “Last Mem. Resume” setting to set up

the TXn so that at startup it will recall the scene

number selected before you turned off the power

to the device.

• Do not turn off the power while the upper part of

the display indicates “Do Not Turn Off!” Other-

wise, a malfunction may occur.

•A small amount of current is ﬂowing even when

the power switch is off. If you will not be using

this device for an extended period of time, be

sure to disconnect the power plug from the AC

outlet.

Hold down the panel [HOME] button for at least

three seconds.

The TXn’s display will show the HOME screen, and

then a message of “Turning power on: Are you sure?”

or “Going Standby: Are you sure?” will appear.

Press the panel [ENTER] button, and the power

status will switch between Standby and On.

• Standby is a state in which the speaker output’s

power amp section is off (operation other than

speaker output will continue).

Hold down the [MUTE] button of the channel you

want to mute for at least one second.

The channel’s output will be muted, and the [MUTE] indica-

tor will light.

To switch mute off, press the [MUTE] button again for at

least one second.

Function buttons

[HOME] button

[MUTE] buttons

[POWER] switch

[ENTER] button

Connecting the AC Power Cable

Turning the Power on and off

CAUTION

NOTE

CAUTION

Switching the Power Status between

Standby and On

Switching Mute on/off

NOTE

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Comments to this Manuals

No comments

Yamaha TX6n Owner's Manual Page 8

Comments to this Manuals

Related products and manuals for Audio amplifiers Yamaha TX6n