Yamaha MG10XUF Owner's Manual Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
Controls and Functions
MG10XUF Owner’s Manual
14
Top panel
Master section (Output: !7 to @7)
!7 [FX SEND] jack
For connecting an external effects unit or a monitor sys-
tem for players. This phone-plug jack outputs the sound
adjusted with the [FX] knob respectively.
!8 [STEREO OUT] jacks
For connecting a powered speaker or amplifier. These
jacks support both XLR and phone plugs.
!9 [PHONES] output jack
For connecting a set of headphones. This jack supports
a stereo phone plug.
NOTE
When the [PFL] indicator @3 is flashing, the signal for chan-
nels where the [PFL] switch
!3 is pressed is output.
@0 [MONITOR OUT] jacks
For connecting a monitor system for operators. These
jacks support phone plugs.
NOTE
The [MONITOR OUT] jacks outputs the same signal as The
[PHONES] jack. When the [PFL] indicator
@3 is flashing, the
signal for channels where the [PFL] switch
!3 is pressed is
output.
@1 [POWER] LED
Lights when the [ / ] switch @9 on the rear panel is
set to on (pressed to the [ ] position).
@2 Level meter
The L and R meters show the level (volume) of the sig-
nal output from the [STEREO OUT] jacks by seven
steps; “PEAK” (+17), “+10”, “+6”, “0”, “-6”, “-10”, and “-20”
dB. If the “PEAK” lamp continuously lights in red, turn
the [STEREO LEVEL] knob to the left to lower the vol-
ume.
@3 [PFL] indicator
When the [PFL] switch is on, the indicator flashes.
@4 [STEREO MUTE] switch
Turning the switch on ( ) will mute the sound of ste-
reo bus from the output of [MONITOR OUT] jacks or
[PHONES] jack. In this state, when setting the [TO
MON /TO ST ] switch !4 for channels 9/10 to [TO
MON ], you can hear the sound only from channels
9/10. For details about the switch, see the “Rear panel
USB section” on page 16.
@5 [MONITOR/PHONES] knob
Adjusts the volume output to the [MONITOR OUT] jacks
and the [PHONES] jack.
@6 [ON] switch
Turn this switch on ( ) to activate the [GROUP] fader.
The switch lights when on.
@7 [STEREO] fader
Adjusts the overall volume output from the [STEREO
OUT] jacks.
Page view 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Comments to this Manuals

No comments