Yamaha AX-390 Owner's Manual download pdf (Page 8)

SPEAKERS

OFF

PHONES

POWER

TAPE 1

MONITOR

AUX

TUNER

PHONO

TAPE 2

CD DIRECT

AMP

VOLUME

NATURAL SOUND STEREO AMPLIFIER AX-390

COPY

BALANCE

BASS

TREBLE

LOUDNESS

Set to the “

∞

” position.

2 Turn the power on.

3 Select the desired input source by pressing the

corresponding input selector button.

* The indicator above the selected button (source) will light

up.

* Note that pressing on each input selector button selects the

source which is connected to the corresponding input

terminals on the rear panel.

4 Select the speakers to be used.

* If you use two speaker systems, press both the A and

B switches.

5 Play the source.

Adjust to the desired output level.

7 If desired, adjust the BASS, TREBLE, BALANCE and

LOUDNESS controls, etc. (refer to page 10).

Notes

●

If you select AUX, PHONO, TUNER or CD, be sure that

TAPE 1 and/or TAPE 2 are not being selected.

●

If you select TAPE 1 and TAPE 2 at the same time, the

result will be the sound from the tape deck 1.

●

For TAPE 1 and TAPE 2, whenever the button is pressed,

the corresponding input source is selected or canceled

alternately.

To turn off the power

Press the POWER switch again.

BASIC OPERATIONS

TO PLAY A SOURCE

SPEAKERS

OFF

AUX

TUNER

PHONO

1, 6

POWER

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Yamaha AX-390 Owner's Manual Page 8

Comments to this Manuals

Related products and manuals for Audio amplifiers Yamaha AX-390