Yamaha 8051510 Installation Manual

KIT NUMBER 8051510 YAMAHA RHINO Electric Steering Installation Manual Thank you for purchasing our ELECTRA-STEER 12v electric assist power s

WIRING YOUR ELECTRA-STEER KIT: 1. The heavy red wire needs to go to a constant positive 12 volts. We normally go to the battery but any constant

Yahama Rhino Supplement For Early Model Year 1. Remove original steering shaft after positioning front wheels straight forward. Cut off the 1/8” bit

In some cases the purple wire maybe substituted for a brown wire!! The Electra-Steer Power Steering Assist Unit is intended to be used in accordanc

4. Once you know what the codes are you can use this chart to tell where or what the problem may be. 5. Once you have determined what the probl

INSTALLATION TIPS: Due to minor variations in vehicle frames, we recommend that you leave all the U-Joint pinch bolts loose until the motor is mounte

Installation Instructions for YAMAHA RHINO 1. Before starting your installation, center your steering wheel and make sure your wheels are in line an

4. Remove the control module bolts from the frame and remove the module. Note: The upper joint and lower shaft have been shipped attached and

5. Your electric motor & module has come to you assembled. Install the bracket, module, & motor assembly over the stock bolt holes in the fr

6. Install the stock bolts from the module to hold the bracket in place. You may have to leave out the bolt closest to the air box to allow pivot ro

8. Once you have confirmed that all is well you will need to drill the 2 extra holes in the frame using the two 3/8” holes in the mtg. bracket as a p

10. Remove the stock 6mm bolts installed in the mounting bracket. Install the module back into its stock location and install the supplied 6mm longe

12. Tighten the u-joint bolts to 20 ft.lbs. 13. Your kit has been shipped with a rubber splash shield. This shield sits over the motor & modu