Yamaha NX-B55 Manual Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 52
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
ii En
En
NOTICE
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This equipment compiles with FCC/IC radiation exposure limits set forth for uncontrolled
equipment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C
to OET65 and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has
very low levels of RF energy that it deemed to comply without maximum permissive
exposure evaluation (MPE). But it is desirable that it should be installed and operated with at
least 20 cm and more between the radiator and person’s body (excluding extremities: hands,
wrists, feet and ankles).
This transmitter must not be co-located or operated in conjunction with any other antenna or
transmitter.
FCC INFORMATION (for US customers)
FCC CAUTION
1 IMPORTANT NOTICE : DO
NOT MODIFY THIS UNIT!
This product, when installed as
indicated in the instructions
contained in this manual, meets
FCC requirements. Modifications
not expressly approved by Yamaha
may void your authority, granted
by the FCC, to use the product.
2
IMPORTANT : When connecting
this product to accessories and/or
another product use only high quality
shielded cables. Cable/s supplied
with this product MUST be used.
Follow all installation instructions.
Failure to follow instructions could
void your FCC authorization to use
this product in the USA.
3 NOTE : This product has been
tested and found to comply with
the requirements listed in FCC
Regulations, Part 15 for Class “B”
digital devices. Compliance with
these requirements provides a
reasonable level of assurance that
your use of this product in a
residential environment will not
result in harmful interference with
other electronic devices.
This equipment generates/uses radio
frequencies and, if not installed and
used according to the instructions
found in the users manual, may cause
interference harmful to the operation
of other electronic devices.
Compliance with FCC regulations
does not guarantee that interference
will not occur in all installations. If
this product is found to be the source
of interference, which can be
determined by turning the unit “OFF”
and “ON”, please try to eliminate the
problem by using one of the following
measures: Relocate either this product
or the device that is being affected by
the interference.
Utilize power outlets that are on
different branch (circuit breaker or
fuse) circuits or install AC line filter/s.
In the case of radio or TV interfer-
ence, relocate/reorient the antenna. If
the antenna lead-in is 300 ohm ribbon
lead, change the lead-in to coaxial
type cable.
If these corrective measures do not
produce satisfactory results, please
contact the local retailer authorized to
distribute this type of product. If you
can not locate the appropriate retailer,
please contact Yamaha Corporation of
America A/V Division, 6600
Orangethorpe Avenue, Buena Park,
CA 90620, USA.
The above statements apply ONLY to
those products distributed by Yamaha
Corporation of America or its
subsidiaries.
Change or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules and RSSGen of IC Rules.
Operation is subject to the following two conditions: 1) this device may not
cause harmful interference, and 2) this device must accept any interference
received including interference that may cause undesired operation of this
device.
See the “Troubleshooting” section at the end of this manual if interference to radio
reception is suspected.
Page view 4
1 2 3 4 5 6 7 8 9 10 ... 51 52

Comments to this Manuals

No comments