Yamaha PSR-400 User Manual download pdf (Page 35)

FEATURE REFERENCE (MIDI)

MIDI

RECEIVE

ON/OFF MODE

□ □

CEiVE O

CLOCK

RECEIVE CHANNEL/CLOCK

The enable/disable status of all MIDI receive channels

is set via the MIDI section RECEIVE CH./CLOCK [A]

and [▼] buttons. The [A] button increments the receive

channel number shown on the display and the [T] button

decrements the receive channel number. The receive chan

nel number is shown on the right two digits of the MULTI

DISPLAY while the status — “E” for enabled or “d” for

disabled — appears on the leftmost digit. The MIDI chan

nel and status display appears while selection is in

progress and for approximately 2 seconds after both MIDI

CH. buttons are released. A *‘C” in place of the channel

number (1 through 16) stands for **CLC1CK/’ and allows

reception of the MIDI clock to turned on or off. If the

[RECEIVE ON/OFF] button is used while the MIDI re

ceive channel or clock display is showing, the status of the

channel or clock can be switched between “E” and “d.”

RtCEIVE

ON/OFF

□

CEIVE a

CLOCK

|STVL£/SP^ITVQ.CE _

E “

-V2£i

______

1 f

style split voice

style; SPLIT VOCE VOICE

P -

style split voice

^ BEAT '

style; SPLIT voice VOICE

P -

STVLE SPLIT VOtCe

Receive channel/clock settings apply to both the Remote Control

and Multi Voice receive modes.

Separate receive channel/clock settings are retained in each

PAGE MEMORY even when the power is turned off (see “PAGE

MEMORY" on page 14 for details).

MODE

The [MODE] button is used to select the MIDI receive

mode in which the PSR-400/PSR-500 is to operate —

Remote Control or Multi Voice.

Press the [MODE] button to call the mode display, then

use the same button to select “00” (Remote Control) or

“99” (Multi Voice).

□

The MIDI MODE is automatically reset to “00" whenever the

power is turned on, when a different PAGE MEMORY is se

lected, or when the DEMO function is used.

■ The Remote Control Mode (Mode 00)

The Remote Control mode should be used when the

PSR-400/PSR-500 is to be connected to a second key

board by which it is to be controlled. In this mode playing

the external keyboard has exactly the same effect as play

ing the PSR-400/PSR-5(X)’s own keyboard. Further the

PSR-400/PSR-5(X) panel controls can be used as normal.

This mode is automatically selected whenever the PSR-

400/PSR-500 is turned on, when a different PAGE

MEMORY is selected, or when the DEMO function is

used.

Data Received In the Remote Control Mode

The PSR-400/PSR-500 receives and responds to the

following data received via the MIDI IN connector when

the Remote Control mode is selected:

• In addition to note and velocity data, the PSR-400/PSR-

500 responds to program change, sustain ON/OFF, vi

brato, volume, pan, reverb (PSR-500 only), start, stop,

and MIDI clock messages.

• Program change messages 00 through 99 correspond to

voices 00 through 99.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 46 47

Comments to this Manuals

No comments

Yamaha PSR-400 User Manual Page 35

Comments to this Manuals

Related products and manuals for Synthesizers Yamaha PSR-400