Yamaha NS-P300 Owner's Manual Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 17
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
11
English
To connect with a YAMAHA DSP amplifier (or AV receiver),
connect the LOW PASS (or SUBWOOFER etc.) terminal on
the rear of the DSP amplifier (or AV receiver) to either the
left (L) or right (R) INPUT2 terminal of the subwoofer.
To connect the subwoofer to the SPLIT SUBWOOFER
terminals on the rear of the DSP amplifier, connect them to
both of the left (L) and right (R) INPUT2 terminals of the
subwoofer.
OUTPUT
TO SPEAKERS
INPUT1
FROM AMPLIFIER
INPUT2
HIGH CUT
AUTO
STANDBY
STANDBY
-
RED
ON
-
GREEN
OFF
LOW
HIGH
POWER
ON
LOW
HIGH
SPLIT SUBWOOFER
LOW PASS
(SUBWOOFER)
OFF
INPUT2
VOLUME
010
Pin plug cords
Amplifier
To AC outlet
To connect the subwoofer to line output (pin jack) terminals of the amplifier
Notes
Some amplifiers have line output terminals labeled PRE
OUT. When you connect the subwoofer to the PRE OUT
terminals of the amplifier, make sure that the amplifier has
at least two sets of PRE OUT terminals. If the amplifier has
only one set of PRE OUT terminals, do not connect the
subwoofer to the PRE OUT terminals. Connect the
subwoofer to the speaker output terminls of the amplifier.
(Refer to pages 8 and 10.)
When connecting to a monaural line output terminal of the
amplifier, connect to either the left or right INPUT2 terminal.
When connected to line output terminals of the amplifier,
other speakers should not be connected to the OUTPUT
terminals on the rear panel of the subwoofer. If connected,
they will not produce sound.
Subwoofer
Main speaker Main speaker
Left Right
Connect the main speakers to the speaker output terminals of the amplifier.
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

Comments to this Manuals

No comments