92 DGX-220/YPG-225 Owner’s Manual
Troubleshooting
Problem Possible Cause and Solution
When the instrument is turned on or off, a popping
sound is temporarily produced.
This is normal and indicates that the instrument is receiving electrical power.
When using a mobile phone, noise is produced.
Using a mobile phone in close proximity to the instrument may produce interfer-
ence. To prevent this, turn off the mobile phone or use it further away from the
instrument.
There is no sound even when the keyboard is played or
when a song or style is being played back.
Check that nothing is connected to the PHONES/OUTPUT jack on the rear
panel. When a set of headphones is plugged into this jack, no sound is output.
Check the Local Control on/off. (See page 80.)
Playing keys in the right hand area of the keyboard
does not produce any sound.
When using the Dictionary function (page 70), the keys in the right hand area
are used only for entering the chord root and type.
• The volume is too soft.
• The sound quality is poor.
• The rhythm stops unexpectedly or will not play.
• The recorded data of the song, etc. does not play cor-
rectly.
• The LCD display suddenly goes dark, and all panel
settings are reset.
The batteries are low or dead. Replace all six batteries with completely new
ones, or use the optional AC adaptor.
The style or song does not play back when the
[START/STOP] button is pressed.
Is External Clock set to ON? Make sure External Clock is set to OFF; refer to
“External Clock” on page 80.
The style does not sound properly.
Make sure that the Style Volume (page 76) is set to an appropriate level.
Is the split point set at an appropriate key for the cords you are playing? Set the
split point at an appropriate key (page 65).
Is the “ACMP ON” indicator showing in the display? If it is not showing press the
[ACMP ON/OFF] button so that it does show.
No rhythm accompaniment plays when the [START/
STOP] button is pressed after selecting style number
121 or a style between 133–150 (Pianist).
This is not a malfunction. Style number 121 and style numbers 133–150 (Pia-
nist) have no rhythm parts, so no rhythm will play. The other parts will begin
playing when you play a chord in the accompaniment range of the keyboard if
style playback is turned on.
Not all of the voices seem to sound, or the sound
seems to be cut off.
The instrument is polyphonic up to a maximum of 32 notes. If the Dual voice or
Split voice is being used and a style or song is playing back at the same time,
some notes/sounds may be omitted (or “stolen”) from the accompaniment or
song.
The footswitch (for sustain) seems to produce the
opposite effect. For example, pressing the footswitch
cuts off the sound and releasing it sustains the sounds.
The polarity of the footswitch is reversed. Make sure that the footswitch plug is
properly connected to the SUSTAIN jack before turning on the power.
The sound of the voice changes from note to note.
This is normal. The AWM tone generation method uses multiple recordings
(samples) of an instrument across the range of the keyboard; thus, the actual
sound of the voice may be slightly different from note to note.
The wrong notes sound when the keyboard is played.
Perhaps the performance assistant technology is turned on.
Press the [PERFORMANCE ASSISTANT] button to turn it off.
The ACMP ON indicator does not appear when the
[ACMP ON/OFF] button is pressed.
Is the [STYLE] button lit? Always press the [STYLE] button first when you are
going to use any style-related function.
There is no harmony sound.
The harmony effects (01–26) behave differently according to their type. Types
01–05 function when style playback is on, chords are played in the accompani-
ment range of the keyboard, and a melody is played in the right-hand range.
Types 06–26 will function whether style playback is on or off. For types 06 = 12
you need to play two notes at the same time.
Appendix
Comments to this Manuals