Yamaha YAS-101 Owner's Manual download pdf (Page 13)

Additional Information

9 En

English

TV remote control operation may be difficult if the unit

hides the sensor of your TV when beneath or under the

TV. Try the two solutions below and see whether this

solves the problem.

1 Move the unit in all directions.

2 Remove the stands to lower the height of

the unit.

Keep the stands and screws in a safe place for future use.

If you cannot solve the problem by the suggestions above,

follow the procedure below and use the TV remote

control signal transmission function, which transmits the

TV remote control signal received at the front of the unit

to the remote control sensor of your TV through the IR

flasher at the rear of the unit.

1 Set the unit to standby mode.

2 Press both the VOLUME + button and

button of the main unit, release the

button first, then release the VOLUME +

button.

The unit is turned on when switching the TV remote

control signal transmission function on/off.

The CLEAR VOICE indicator lights up as the

following illustration. Check if the setting is correct.

(☞ P. 11)

• The default setting is off.

• You can verify the current setting by turning the

unit on again from standby mode.

• Move the unit in all directions again if TV remote control

remains difficult.

• The TV remote control signal transmission function is

enabled even if the unit is in standby mode.

You can use the TV remote control solely to operate by

having the unit learn the TV remote control operations.

You can operate the following functions by TV remote

control.

• Volume down

• Volume up

• Power on/standby mode

Some TV remote controls may not control these functions.

Use the remote control supplied with the unit in this case.

1 Set the unit and TV to standby mode.

2 Press both the INPUT button and

button of the main unit, release the

button first, then release the INPUT

button.

The unit enters the remote control

learning mode.

Operation by the TV remote control is

difficult (with unit beneath/under TV)

Note

Using TV remote control signal

transmission function

Use a + driver to

remove the screws.

The unit will be

19 mm lower without

the stands.

The remote

control sensor of

your TV

IR flasher

On Off

The CLEAR

VOICE indicator

(for 2 seconds

after the unit is

turned on)

Notes

Operate the unit by TV remote control

(TV remote control learning function)

No light Green

Flashes in

red

Continued to the next page.

1 ... 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Yamaha YAS-101 Owner's Manual Page 13

Comments to this Manuals

Related products and manuals for Supplementary music equipment Yamaha YAS-101