Yamaha QY8 Specifications download pdf (Page 41)

Creating an Accompaniment

4-4. Press [ENTER] to enter the selected end mark or repeat at the

current measure. A dot will appear on the 1 MEASURE bar to

indicate that an end mark or repeat has been entered at that

location.

4-5. Repeat steps 4-2 through 4-4 until all required repeats have been

entered.

Deleting Repeats

To delete a repeat, move the cursor to the dot on the 1 MEASURE

bar corresponding to the change you want to delete, then press the

[ENTER] button. An alternative method is to use the [ ] and

[ ] buttons to locate the measure containing the repeat to be

deleted, select the “blank” repeat (indicated by a row of flashing

blocks), and press [ENTER].

DETAIL

• Improperly used repeats (e.g. :|| without a corresponding ||:

mark)will

be ignored.

• You cannot enter repeats within repeats (i.e. “nested” repeats).

HINT

The copy and delete functions described in chapter 7 (pages 54,

51) can make the process of creating songs faster and more

efficient.

IMPORTANT

Depending on the amount of data you have recorded, it may not

be possible to fully record all 20 available songs. If you run out of

memory during recording, the “MemFull” error message will appear

on the display. If this happens use the Clear Song function

described on page 60 to clear unwanted song data. You might also

want to use an optional Yamaha MDF2 MIDI Data Filer to save your

important song data to floppy disk for later loading and use.

5. Play Back and Check Out Your Song

5-1. Move the cursor to the SONG SELECT pointer (▲) to select the

song select mode.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 89 90

No comments

Yamaha QY8 Specifications Page 41