Yamaha YSP-900 Owner's Manual download pdf (Page 34)

AUTO SETUP (IntelliBeam)

32 En

8 Check that the following screen is displayed

on your TV.

The results of the AUTO SETUP procedure are

displayed on your TV.

• If ‘‘ENVIRONMENT CHECK [FAILED]’’ is

displayed, we recommend running the AUTO SETUP

procedure again. For details, see step 9.

• If ‘‘SUBWOOFER : NOT APPLICABLE’’ is

displayed even though a subwoofer is connected to this

unit, increase the volume level of the subwoofer and

run the AUTO SETUP procedure again.

• Depending on the environment of your listening room,

the beam angle of front left and right, and surround left

and right may be set to the same value even if 5BEAM

is displayed as a result.

9 Press ENTER to confirm the results or press

RETURN to cancel the results.

The following screen is displayed temporarily for 2

seconds and then disappears from your TV.

If ‘‘ENVIRONMENT CHECK [FAILED]’’ is displayed in

step 8, the following screen is displayed after pressing

ENTER. In this case, see ERROR E-1 in “Error messages

for AUTO SETUP” on page 33. Press ENTER to exit the

AUTO SETUP and then run the procedure again from

step 3.

10 Disconnect the optimizer microphone from

the OPTIMIZER MIC jack on the front panel.

Example 1

Example 2

ENTER

OPTIMIZER MIC

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 271 272

No comments

Yamaha YSP-900 Owner's Manual Page 34