Yamaha HTR-6040 Owner's Manual download pdf (Page 27)

23 En

Optimizing the speaker setting for your listening room

English

PREPARATION

4 Set the operation mode selector (K) to AMP

and then press

l / h to select “AUTO”.

Choices: AUTO, RELOAD, UNDO, DEFAULT

• Select “AUTO” to automatically run the entire

“AUTO SETUP” procedure.

• Select “RELOAD” to reload the last “AUTO

SETUP” settings and override the previous

settings.

• Select “UNDO” to undo the last “AUTO SETUP”

settings and restore the previous settings.

• Select “DEFAULT” to reset the “AUTO SETUP”

parameters to the initial factory settings.

“RELOAD” or “UNDO” is available only when you have

previously run “AUTO SETUP” and confirmed the results.

5 Press

n to select “START” and then press

ENTER to start the setup procedure.

This unit starts the auto setup procedure. Loud test

tones are output from each speaker during the auto

setup procedure. Once all items are set, the

“AUTO:RESULT” display appears in the OSD.

• During the auto setup procedure, do not perform any

operation on this unit.

• We recommend getting out of the room while this unit is in

the auto setup procedure. It takes approximately 3 minutes

for this unit to complete the auto setup procedure.

This unit performs the following checks:

Speaker wiring/volume level WIRING/LEVEL

Checks which speakers are connected and the

polarity of each speaker. Also checks and adjusts the

volume level of each speaker.

Speaker distance DISTANCE

Checks the distance of each speaker from the

listening position and adjusts the timing of each

channel.

Speaker size SIZE

Checks the frequency response of each speaker and

sets the appropriate low-frequency crossover for each

channel.

The display changes as follows.

The results displayed under “RESULT” are as follows.

Number of speakers SP

Displays the number of speakers connected to this unit in

the following order:

Front/Back/Subwoofer

Speaker distance DIST

Displays the speaker distance from the listening position

in the following order:

Closest speaker distance/Farthest speaker distance

Speaker level LVL

Displays the speaker output level in the following order:

Lowest speaker output level/Highest speaker output level

• If “E-6:INTERNAL ERROR” appears during the testing

procedure, restart from step 4.

• If you selected “RELOAD” in step 4, no test tones are output.

• If an error occurs during the “AUTO:CHECK” procedure, the

setup procedure is canceled and an error screen appears. For

details, see “If an error screen appears” on page 25.

• When this unit detects potential problems during the “AUTO

SETUP” procedure, “WARNING” and the number of warning

messages appears in the above of “RESULT” (see page 25).

Note

Notes

AUTO:MENU

SETUP;;;;;;;AUTO

. START

Automatic

Processing

of all item

[ ]/[ ]:Up/Down

[ENTER]:Start

AUTO:RESULT

NO WARNING

RESULT

SP : 3/2/0.1

DIST: 3.2/3.5m

LVL : -2/+2dB

. SET CANCEL

[ ]/[ ]:Up/Down

[ENTER]:Enter

INITIALIZING

. WIRING/LEVEL

DISTANCE

SIZE



WAITING;;;

;;;;;;;;;;

[]:Exit

[

AUTO:CHECK

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 92 93

Comments to this Manuals

No comments

Yamaha HTR-6040 Owner's Manual Page 27

Comments to this Manuals

Related products and manuals for Receiver Yamaha HTR-6040