Yamaha RMio64-D Firmware User Manual

1 RMio64-D Firmware Update Guide Thank you for choosing a Yamaha product. This guide explains how to update the RMio64-D firmware and its built-in Da

10 Updating the Dante firmware Described below are the procedures to update the Dante module firmware integrated in the RMio64-D unit. • To update

11 5. Click [Update Dante Firmware]. 6. Click [Browse] and select “FWUpdate_RMio64D-vxxx-swyyy.dnt,” then click [Open]. The characters “xxx” and “yy

12 If the RMio64-D is not indicated, click [Refresh]. If this field is empty, your computer may not be properly connected to the RMio64-D. Check tha

13 About Failsafe Mode During normal operation, software must be loaded from a flash memory drive during operations to use the Dante module integrat

14 6. Disable all but one of the network interfaces on your computer. 7. Run the Dante Firmware Update Manager as described below. Windows Select [A

15 Error Message List (RMio64-D Update Program) Error messages for the RMio64-D Update Program may be displayed on the computer. This section explai

2 Update procedure sequence Update each firmware component in the following sequence. Preparing for the update ↓ Updating the RMio64-D firmwa

3 Preparing for the update 1. Download the latest firmware from the following URL. http://www.yamahaproaudio.com/downloads/ 2. Decompress the down

4 Updating the RMio64-D firmware This section explains how to update the RMio64-D firmware. • Before you start updating the firmware, decompress

5 5. Make sure that the fields in the “File” section indicate as follows: File name: RMio64-D_firmXXX.prg Product name: RMio64-D Version: X.XX •

6 Installing the Dante Firmware Update Manager The Dante Firmware Update Manager is software for updating the Dante firmware. The Dante Firmware Upd

7 Computer TCP/IP setting To update Dante firmware, configure computer TCP/IP settings. After the firmware update procedure is complete, return the

8 5. Click [Obtain an IP address automatically]. 6. Click [OK].

9 Mac 1. Click the “System Preferences” icon on Dock. The “System Preferences” window appears. 2. Click the [Network] icon. The “Network” window ap