Yamaha MD8 Owner's Manual download pdf (Page 37)

Manual Punch In/Out 29

MD8—Owner’s Manual

Manual Punch In/Out

The Punch In/Out technique allows you to rerecord speciﬁc sections of a track. This can be

used to correct mistakes or record something new into silent sections of a track. If you’re

operating the MD8 and playing or singing the part to be recorded, you’ll ﬁnd it much easier

to use the Auto Punch In/Out function, which performs the punch in/out automatically. See

Auto Punch In/Out on page 32 for more information.

Manual punch in/out can be performed in three different ways: 1) using the [REC] button.

2) using the individual [REC SELECT] buttons. 3) using an optional footswitch. The

Rehearsal function can be used with all three methods.

Using the REC Button

1. Locate to a position before the point at which you want to punch in.

2. Press the [REC SELECT] button (or [GROUP] + [REC SELECT]) of the track

that you want to record.

See Recording the First Track on page 17 for more information.

A dot ﬂashes above the corresponding track indicator (DIR or GRP).

3. Press the [PLAY] button to start playback.

Playback starts and the PLAY indicators light up.

4. At the point where you want to punch in, press the [REC] button.

Recording starts. The REC indicators light up. The dot stops ﬂashing and lights up contin-

uously. And the LAST REC IN indicator lights up, indicating that the IN point has been

stored.

If you’re monitoring the track via CUE, you’ll hear the existing sound playback until the

[REC] button is pressed, after which you’ll hear the new sound that’s being recorded.

Instead of pressing the [REC] button you could have pressed the [REHE] button to engage

Rehearse mode. Rehearse allows you to have a dry run before actually recording. In Rehearse

mode, the REHE indicators light up, not the REC indicators.

5. At the point where you want to punch out, press the [PLAY] button.

Recording stops. The REC indicators go off. The dot above the track indicator ﬂashes, and

the LAST REC OUT indicator lights up, indicating that the OUT point has been stored.

Through the CUE monitor you’ll hear the existing sound playback.

6. Press the [STOP] button to stop playback.

The following illustration shows how punch in/out works with the [REC] button.

In Point

Play

REC

SELECT

PlayRecord

Out Point

RECPLAY STOPPLAY

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 114 115

No comments

Yamaha MD8 Owner's Manual Page 37