Yamaha A-S3000 Owner's Manual download pdf (Page 20)

20 En

Connections

■ Connecting to the BAL 1/BAL 2 jacks

Connect your CD player or network player with the XLR

balanced output jacks.

Set the ATTENUATOR selector and PHASE selector

located below the BAL 1 or BAL 2 jacks according to the

component to be connected.

ATTENUATOR selector:

Select the allowable input level for the XLR balanced

input jacks. If sound from the connected component is

distorted, set the ATTENUATOR selector to ATT. (-6 dB).

PHASE selector:

Select the assignment of the HOT pin of the XLR

balanced input jacks (pin 2 HOT or pin 3 HOT).

NORMAL (pin 2 HOT)

INV. (pin 3 HOT)

Refer to the owner’s manual supplied with the connected

component and verify the assignment of the HOT pin of

its XLR balanced output jacks.

Yamaha CD players are set to NORMAL (pin 2 HOT).

XLR connectors:

When connecting, be sure to match the pins and insert the

connector of the “male” XLR balanced cable until you

hear a “click”. When disconnecting, pull out the “male”

XLR balanced cable while holding down the lever of the

BAL 1 or BAL 2 jack.

To use the XLR balanced connection, you must select BAL 1 or

BAL 2 as the input source.

1: ground2: hot

3: cold

1: ground2: cold

3: hot

Note

“Female” XLR connector

“Male” XLR connector

Lever

BAL 1/BAL 2 jack

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 57 58

No comments

Yamaha A-S3000 Owner's Manual Page 20