Yamaha HTR-6090 User Manual Page 35

  • Download
  • Add to my manuals
  • Print
  • Page
    / 152
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 34
AUTO SETUP
31 En
PREPARATION
This unit employs the YPAO (YAMAHA Parametric Room Acoustic Optimizer) technology which lets you avoid
troublesome listening-based speaker setup and achieves highly accurate sound adjustments automatically. The supplied
optimizer microphone collects and this unit analyzes the sound your speakers produce in your actual listening
environment.
Once you have connected the supplied optimizer
microphone to the OPTIMIZER MIC jack on the front
panel and have placed it in a suitable location in your
listening room, run “AUTO SETUP” in the OSD or in the
front panel display.
Be advised that it is normal for loud test tones to be output
during the “AUTO SETUP” procedure.
To achieve the best results, make sure the room is as quiet as
possible while the “AUTO SETUP” procedure is in progress. If
there is too much ambient noise, the results may not be
satisfactory.
y
You can run “AUTO SETUP” using the system menu that
appears in the OSD or in the front panel display. This manual
uses the OSD illustrations to explain the “AUTO SETUP”
procedure.
If an error occurs during the “AUTO SETUP” procedure and an
error or warning message appears in the OSD or in the front
panel display, see the “AUTO SETUP” section in
“TROUBLESHOOTING” on pages 128 and 129 for a complete
list of error and warning messages and proper remedies.
The initial setting for each parameter is indicated in bold.
If the volume level and the crossover frequency of your
subwoofer can be adjusted, set the volume level to about half
way (or slightly less) and set the crossover frequency to the
maximum.
1 Connect the supplied optimizer microphone
to the OPTIMIZER MIC jack on the front
panel.
2 Place the optimizer microphone at your
normal listening position on a flat level
surface with the omni-directional
microphone heading upward.
y
It is recommended that you use a tripod (etc.) to affix the
optimizer microphone at the same height as your ears would be
when you are seated in your listening position. You can use a 6
mm diameter screw to fix the optimizer microphone to a tripod
(etc.).
AUTO SETUP
Using AUTO SETUP
Notes
+
+
+
ENTER
DISPLAY
AUDI O
MENU
TITLE
TV MUTE
TV INPUT
MUTE
RETURN
VOLUME
CH
TV VOL
EFFECT
PARAMETER
STRAIGHT
XM MEMORY
A-E/CAT.
SRCH MODE
PURE DIRECT
PRESET/CH
SET MENU
BAND
LEVEL
TV
SOURCE
AMP
3-13
4,14
4
ENHANCER
SILENT CINEMA
NIGHT
PHONES
OPTIMIZER MIC
MASTER
ON
OFF
Omni-directional
microphone
Optimizer microphone
01EN_00_HTR-6090_U.book Page 31 Tuesday, June 27, 2006 6:40 PM
Page view 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 151 152

Comments to this Manuals

No comments