Yamaha SA500 User Manual download pdf (Page 185)

User’s Manual 8-13

Optional Devices

Disconnecting an eSATA device

When you have finished using an eSATA device, you can follow the

procedures below in order to disconnect it:

1. Wait for the indicator light of an eSATA device to go out to make sure all

activity has stopped.

2. Click the Safely Remove Hardware icon on the Windows Taskbar.

3. Click the eSATA device that you want to remove.

4. Carefully pull the eSATA device's USB (eSATA combo) connector out

from within the computer's USB (eSATA combo) port.

External monitor

An external analog monitor can be connected to the computer's external

monitor port, with the computer supporting WUXGA video mode. In order to

connect a monitor, follow the steps as detailed below:

1. Turn the computer's power off.

2. Connect the monitor cable to the external monitor port and tighten the

screws on the left and right hand side of the connector as required.

■ A connected eSATA device may not be recognized if it is connected to

the computer's eSATA/USB combo port while the computer is in Sleep

Mode or Hibernation Mode. If this occurs, disconnect the eSATA device

and then reconnect the device while the computer is turned on.

■ If you connect an eSATA device after the computer has already been

turned on, it will take about ten seconds for it to be recognized by the

computer.

Do not attempt to disconnect and reconnect the drive before this period

has elapsed.

If you disconnect an eSATA device or turn off the power while the

computer is accessing the drive you may lose data or damage an eSATA

device or the drive.

1 2 ... 180 181 182 183 184 185 186 187 188 189 190 ... 257 258

No comments

Yamaha SA500 User Manual Page 185