Yamaha NUAGE Workgroup Manager Operations Manual download pdf (Page 9)

Descriptions of Windows

NUAGE Workgroup Manager Operation Manual 9

Setup window

Overview

The Setup window is used to configure communication

settings. Tab names correspond to the assignments

indicated by Assign (page 7) on the Main window. You

can select devices by clicking the corresponding tabs. To

open this window, click Setup (page 7) on the Main

window.

Component names and functions

1 Network Interface

This drop-down list is used to select the network adaptor

on your computer that will be used with NUAGE

Workgroup Manager.

2 Auto Register

Select this check box to turn the Automatic Registration

function on and clear to turn it off. If devices or DAW

applications not currently in the Workgroup are identified

on the network while this function is on, you will be asked

whether or not you wish to add them to the Workgroup.

3 KVM Serial Data

These fields are used to enter the ASCII messages to be

sent to KVM switches in order to switch them. For details

on this data, refer to the manual that came with the KVM

switch in question. Control characters should be entered

as follows.

4 RS232C Parameters

This area is used to set parameters for the data

transmitted from the RS-232C port the rear of the Nuage

Fader or Nuage Master.

About window

Overview

The About window displays the current NUAGE

Workgroup Manager version (shown as “x.x.x” here). To

open this window, click About (page 7) on the Main

window.

Control character Text to be entered

LF \n

CR \r

\\\

Parameter Settings

Bit Rate [bps] 4800, 9600, 19200, 38400, 57600, and

115200

Data Bits 7 and 8

Stop Bits 1 and 2

Parity Bits NONE, EVEN, and ODD

1 2 3 4 5 6 7 8 9 10 11

Comments to this Manuals

No comments

Yamaha NUAGE Workgroup Manager Operations Manual Page 9

Comments to this Manuals