Yamaha DSP5D User's Guide download pdf

DSP5D Upgrade Guide

This document explains how to update the DSP5D firmware to the latest version.

Precautions (Please be sure to read this section first!)

・ The user assumes full responsibility for the update.

・ Back up all important data before updating.

・ If the DSP5D is cascade-connected to the PM5D, you may also need to update the PM5D when

updating the DSP5D. First check the PM5D firmware version as to whether it supports the DSP5D or

not, then update the PM5D. If the DSP5D is cascade-connected to an unsupported firmware version

of the PM5D, an error message “PM5D Unsupported Firmware Version” will be shown.

・ If you fail to follow these instructions properly, or turn off the DSP5D or unplug the cable while the

update is in progress, the DSP5D may be damaged.

・ If the DSP5D does not work properly after updating, and you’ve tried updating several times, please

contact your Yamaha dealer.

・ This documentation is copyrighted by Yamaha Corporation.

・ Reproducing or modifying all or part of this documentation without permission is strictly prohibited.

System Requirements

The system requirements below are necessary for updating the firmware.

・ An Ethernet port equipped computer with the DME-N Network Driver installed

(For details on the system requirements refer to the DSP5D Editor Installation Guide.)

・ One Ethernet cable

(If a single DSP5D is connected directly to the computer, you can use either a cross cable or straight

cable.)

DSP5D Upgrade Guide 1

1 2 3 4 5 6 7

DSP5D Upgrade Guide This document explains how to update the DSP5D firmware to the latest version. Precautions (Please be sure to read this section

Preparing for the update 1. Connect the computer to the DSP5D with an Ethernet cable. Yamaha recommends that you connect the computer directly to a

Update Procedure The numbers below correspond to the DSP5D Loader step number. 1. Press the POWER switch (A) of the DSP5D to turn it on. Click the [

NOTE: If an error message appears when you click the [Start] button, check the following. • Does the folder selected in the “Load File” field cont

6. Specify the following settings, then click the [Load] button to start the Main CPU update. When the update is complete, a “Complete" message

8. Click the [Done] button to finish the DSP5D Loader. When the update is complete, make sure to initialize the memory by following the procedure

OUTTX RX TX RXIN OUTTX RX TX RXIN OUTTX RX TX RXIN OUTTX RX TX RXIN 4. The OUT [TX] LED flashes and the other three LEDs light. OUTTX RX TX RXINO

No comments

Yamaha DSP5D User's Guide