Yamaha NS-P350 Owner's Manual download pdf (Page 4)

2 En

Installing the speakers

Place the center speaker centrally between the front

speakers, facing directly forward.

When placing it on a flat surface (TV rack, etc), affix the

supplied fasteners to bottom of the speaker.

Refer to the illustration.

Wipe the surface clean before affixing the fasteners. If the

surface is dirty, oily or wet, adhesive strength is weakened

and the speaker may fall.

You can mount the speakers on the wall as follows.

1 Install screws into a solid wall or wall support as

shown in the illustration. Use 3.5 to 4 mm (1/8")

diameter self-tapping screws.

2 Hang each speaker by its keyhole slots onto the

protruding screws.

Make sure the shaft of the screw is seated in the narrow

part of the keyhole slot. Otherwise, the speaker may

fall.

• Do not mount the speakers on thin plywood or on a wall with a soft surface material. Otherwise, the screws may pull

out of the surface and the speakers may fall, possibly damaging the speakers or causing personal injury.

• Do not install the speaker on a wall using nails, adhesives, or any other unstable hardware. Long term use and vibration

may cause it to fall.

• Be careful not to pinch the speaker cables between the speaker and the speaker bracket or speaker stand.

• To avoid accidents resulting from tripping over loose speaker cable, affix them securely to the wall.

• When using speaker brackets (commercially available) to mount the speakers on the wall or ceiling, we strongly

recommend using safety wire (may be supplied with the bracket) between the speaker and bracket to prevent the

speaker from falling.

• If you are not sure of a safe way to install these speakers, consult a professional installer or a building contractor.

Installing the center speaker

Peel off the seal.

TV rack, etc.

Fastener

Note

Wall-mounting the speakers

Wall/

wall support

3mm

(1/8")

Minimum

20 mm (3/4")

NS-PB350

4.8kg (10lbs. 9oz.)

40 mm

(1-5/8")

Note

Using a commercially-available speaker

stand

60 mm

(2-3/8")

Bottom

(Front)

(Rear)

45 mm

(1-3/4")

If you mount the speaker on a

commercially-available speaker

stand, use the mounting screw

holes on the bottom of the speaker.

NS-PB350

Screw holes

Diameter:

4 mm (1/8")

Hole depth:

10 mm (3/8")

Warning

1 2 3 4 5 6 7 8 9 ... 31 32

Comments to this Manuals

No comments

Yamaha NS-P350 Owner's Manual Page 4

Comments to this Manuals

Related products and manuals for Flat panel floor stands Yamaha NS-P350