Yamaha DVX-700 Owner's Manual Page 22

  • Download
  • Add to my manuals
  • Print
  • Page
    / 86
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 21
OTHER CONNECTIONS
18 En
Connecting an HDMI component
HDMI (High-Definition Multimedia Interface) is the first
industry-supported, uncompressed, all-digital A/V (audio/
video) interface.
By connecting to an HDMI component (such as a TV),
you can enjoy standard, enhanced or high-definition video
as well as digital audio using a single cable.
When used in combination with HDCP (High-bandwidth
Digital Content Protection), HDMI provides a secure
audio/video interface that meets the security requirements
of content providers and system operators.
For further information on HDMI, visit the HDMI website
at “http://www.hdmi.org/”.
Viewing and Listening to playback
from an HDMI component
To output an HDMI signal, you need to configure the
settings manually. It is necessary to prepare in advance to
output an HDMI signal.
1 Set the system to standby mode.
2 Connect the HDMI terminals on your HDMI
compatible device and the DVD controller using a
commercially available HDMI cable.
3 To output an audio signal from the DVD controller to
the HDMI compatible device, refer to “System menu”
on page 65.
After doing the settings, set the DVD controller to
standby mode, and then turn on the system again.
4 To set the video output according to the HDMI
compatible device, refer to “Video Output” on
page 38 to access the DVD setup menu, and then set
the two items under Video output in the system menu.
HDMI Resolution
HDMI Color
Notes
This unit is designed to connect to HDMI
compatible devices. If you connect to the DVI
component, the system may not operate correctly.
The DVD controller is not compatible with HDCP-
incompatible HDMI or DVI components.
You need a commercially available HDMI/DVI
conversion cable when you connect the DVD
controller to other DVI components.
If you connect the system to the DVI component
with a HDMI/DVI conversion cable, the HDMI
terminal of the DVD controller does not output any
audio signals.
Do not disconnect or connect the HDMI cable from
the DVD controller or turn off the power of the
HDMI/DVI component connected to the HDMI
OUTPUT terminal of the DVD controller while
data is being transferred. Doing so may disrupt
playback or cause noise.
PCM signal downmixed to two channels can be
output from the HDMI output terminal.
Connecting the FM antenna
Connect an indoor FM antenna to the ANTENNA
terminal. Extend the FM antenna and fix its ends to the
wall.
For better FM stereo reception, connect an external FM
antenna.
Notes
Adjust the position of the antenna for optimal
reception.
Position the antenna as far as possible from your
TV, VCR or other sources of radiation to prevent
unwanted interference.
VIDEO
COMPONENT
P
R
VIDEO
OUTPUT
Y
P
B
HDMI
OUTPUT
HDMI
IN
TV
DVD controller
FM
75
UNBAL
.
ANTENNA
INPUT
Subwoofer/system control
Page view 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 85 86

Comments to this Manuals

No comments