Yamaha DVD-S2500 Owner's Manual download pdf (Page 23)

English

On-screen menu

Connection Status

This screen shows components connected using the

i.LINK interface, and the transfer capabilities of each

component with respect to Dolby Digital, DTS and

MPEG audio formats.

Choices: Component 1, Component 2, ...

Initial setting: Component 1

Screen Sample

Notes:

– If [PCM] is selected for Digital Output in Setup –

Audio Menu, all signals are converted to PCM

format before being output.

– An “*” (asterisk) appears next to the name of the

component initially recognized by this unit. The

audio signal output format is determined by the

transfer capabilities of the component, and signals

are output to all connected components.

– The component name is displayed only when the

i.LINK receiver component connected to this unit

supports i.LINK (AUDIO). The component name is

not displayed for DVD players or DV camcorders.

– If the i.LINK component connected to this unit does

not contain any device name information, “****” is

displayed.

AutoPlay Select

You can use this setting to specify a receiver for

automatically switching the input to this player when

you start playback of a disc.

Choices: Off, Component 1, Component 2, ...

Initial setting: Off

Information about the operational status of this unit is

displayed in the front panel display as follows:

Note:

– The i.LINK indicator located on the front panel of

this unit lights only when i.LINK is selected for an AV

amplifier connected to this unit via an i.LINK

interface. Even if [Off] is selected for Audio Output

in the on-screen menu, the i.LINK indicator lights

whenever i.LINK is selected on the connected AV

amplifier.

* RX-Z9

Connection Status

Dolby D

➔

Dolby D

DTS ➔ DTS

MPEG ➔ PCM

i.LINK

Display Status

BUS FULL

Displayed when data transfer is not possible

because you are already using the allowable

maximum bandwidth of the i.LINK bus or

when 17 or more i.LINK components are

connected to this unit.

LINKING

Displayed when this unit is checking a new

i.LINK connection.

LOOP CHECK

Displayed when this unit and the i.LINK

component are connected in a loop (where

the output signal is returned to the original

component).

NO OUTPUT

Displayed when an i.LINK connection was

activated, but either the new connection is

not recognized by DTCP, or the amplifier

connected to this unit does not allow

transmission.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 34 35

Comments to this Manuals

No comments

Yamaha DVD-S2500 Owner's Manual Page 23

Comments to this Manuals

Related products and manuals for DVD players Yamaha DVD-S2500