Yamaha ATS-1050 Manual download pdf (Page 16)

Clearing all programmed functions

1 With the sound bar turned off, hold down the LEARN key on the

sound bar’s remote control for more than 3 seconds (for entering the

learning mode).

When the sound bar is in the learning mode, the indicators on the top panel flash as

shown below.

2 Hold down (input) on the rear panel of the sound bar for more

than 3 seconds.

The corresponding indicator of the learned function turns off and the indicators on

the top panel flash as shown below.

If the clearing is completed, you will hear the bleep sound three times.

3 Press the LEARN key on the sound bar’s remote control.

The sound bar has dual built-in subwoofers; however you can connect an external

subwoofer when you want to enhance low frequency sound. Connect a subwoofer to the

SUBWOOFER OUT jack of the sound bar. Sound is output from both the built-in

subwoofers and external subwoofer.

NOTE

• Use an external subwoofer with built-in amplifier.

LEARN BLUETOOTH

STANDBY

Using an external subwoofer

SUBWOOFER OUT

Pin cable for subwoofer

(commercially available)

Mono input

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 146 147

No comments

Yamaha ATS-1050 Manual Page 16