Yamaha RX-V775 Setup Guide download pdf (Page 8)

En 7

Use the cursor keys to select

“Save/Cancel” and press ENTER.

Use the cursor keys to select “SAVE” and

press ENTER.

Disconnect the YPAO microphone from the

unit.

This completes optimization of the speaker settings.

Follow the procedure below to check the speaker

connections.

a Use the cursor keys to select “Result” and press ENTER.

b Use the cursor keys to select “Wiring”.

c Check the cable connections (+/–) of the speaker that

was identified as being “Reverse” in the warning

message.

If the speaker is connected correctly:

Depending on the type of speakers or room

environment, this message may appear even if the

speakers are connected correctly.

In this case, you can ignore the message.

Press RETURN and proceed to step 3.

If the speaker is connected incorrectly:

Turn off the unit, reconnect the speaker cable, and then

try YPAO measurement again.

• The YPAO microphone is sensitive to heat, so should not be

placed anywhere where it could be exposed to direct sunlight or

high temperatures (such as on top of AV equipment).

If “W-1:Out of Phase” appears

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

No comments

Yamaha RX-V775 Setup Guide Page 8