Yamaha RX-V520RDS Owner's Manual download pdf (Page 14)

■ Connecting an MD recorder, CD

recorder or tape deck

• When you connect your recording component to both the analog

and digital input and output jacks, the priority is given to the

digital signal.

Notes

• When you connect a recording component to this unit, keep its

power on while using this unit. If the power is off, this unit may

distort the sound from other components.

• Since digital output and analog output (REC OUT) are

independent of each other, the analog signal is output only to the

analog jack, while the digital signal is output only to the digital

jack.

Connecting an External Decoder

This unit is equipped with 6 additional input jacks (left and

right MAIN, CENTER, left and right SURROUND and

SUBWOOFER) for discrete multi-channel input from an

external decoder, sound processor or pre-amplifier.

Connect the output jacks on your external decoder to the

6CH INPUT jacks. Be sure to match the left and right

outputs to the left and right input jacks for the main and

surround channels.

Notes

• When you select 6CH INPUT as the input source, this unit

automatically turns off the digital sound field processor, and you

cannot listen to DSP programs.

• When you select 6CH INPUT as the input source, changing items

of “1 SPEAKER SET” in the SET MENU is not affected (except

“MAIN LVL”).

CONNECTIONS

Connecting Audio Components

■ Connecting to digital jacks

This unit has digital jacks for direct transmission of digital

signals through either coaxial or fiber optic cables. You can

use the digital jacks to input PCM, Dolby Digital and DTS

bitstreams. When you connect components to both the

COAXIAL and OPTICAL jacks, priority is given to the

input signals from the COAXIAL jack. All digital input

jacks are acceptable for 96-kHz sampling digital signals.

• You can designate the input for each digital jack according to

your component by using “3 I/O ASSIGN” in the SET MENU.

About the dust protection cap

Pull out the cap from the optical jack before

you connect the fiber optic cable. Do not

discard the cap. When you are not using the

optical jack, be sure to put the cap back in

place. This cap protects the jack from dust.

Note

• The OPTICAL jacks on this unit conform to the EIA standard. If

you use a fiber optic cable that does not conform to this standard,

this unit may not function properly.

■ Connecting a CD player

• The COAXIAL jack is available for a CD player which has

coaxial digital output jack.

• When you connect a CD player to both the analog and digital

jacks, priority is given to the input signals from the digital jack.

0103V520RDS10-20_EN 1/31/1, 4:21 PM12

1 ... 13 14 15 ... 71

Comments to this Manuals

No comments

Yamaha RX-V520RDS Owner's Manual Page 14

Comments to this Manuals

Related products and manuals for AV receivers Yamaha RX-V520RDS