Yamaha RX-V467 Manual download pdf (Page 12)

En 12

CONNECTIONS

Connecting speakers

■

(U.S.A. and Canada models only)

Changing speaker impedance

This unit is configured for 8Ω speakers as the factory setting.

When connecting to 6Ω speakers, carry out the following

procedure to switch to 6Ω.

Switch this unit to the standby mode.

Press A while pressing and holding STRAIGHT on

the front panel.

Release the keys when “ADVANCED SETUP” is displayed on

the front panel display.

After approximately a few seconds, the top menu items are

displayed. J1

Check that “SP IMP.” is displayed on the front panel.

Press STRAIGHT repeatedly to select a “6ΩMIN.”

Switch this unit to the standby mode, and then

switch it on again.

The power turns on, when the settings you made has been

configured.

■

Connecting speakers

Remove approximately 10 mm of insulation from the

ends of the speaker cables, and twist the bare wires

of the cables together firmly so that they will not

cause short circuits.

Loosen the speaker terminals.

Insert the bare wire of the speaker cable into the gap

on the side of the terminal.

Tighten the terminal.

PHONES

SILENT

CINEMA

TONE

CONTROL

STRAIGHT

DVD

RADIO

INPUT

PROGRAM

SCENE

INFO

MEMORY

PRESET

FM AM

YPAO MIC

STRAIGHT

PROGRAM l / h

SPIMP.-8MIN

FRONT

Connecting the banana plug (Except U.K., Europe,

Asia and Korea models)

Tighten the knob, and then insert the banana plug into the end of

the terminal.

FRONT

Banana plug

1 : Refer to the “Extended functionality that can be configured as needed

(Advanced Setup menu)” (☞

p. 65) for details on the Advanced Setup menu.

1 ... 11 12 13 ... 91

Comments to this Manuals

No comments

Yamaha RX-V467 Manual Page 12

Comments to this Manuals

Related products and manuals for AV receivers Yamaha RX-V467