Yamaha RX-V365 Owner's Manual Page 48

  • Download
  • Add to my manuals
  • Print
  • Page
    / 62
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 47
44 En
Troubleshooting
iPod
Note
In case of a transmission error without a status message appearing on the front panel display, check the connection to your iPod (see page 14).
Bluetooth
AM
The desired station
cannot be tuned into
with the automatic
tuning method.
The signal is weak or the antenna
connections are loose.
Tighten the AM loop antenna connections and
orient it for the best reception.
Use the manual tuning method. 27
There are continuous
crackling and hissing
noises.
Noises result from lightning,
fluorescent lamps, motors, thermostats
and other electrical equipment.
Use an outdoor antenna and a ground wire.
This will help somewhat, but it is difficult to
eliminate all noise.
There are buzzing and
whining noises.
A TV set is being used nearby. Move this unit away from the TV set.
Status message Cause Remedy
See
page
Connect error There is a problem with the signal path
from your iPod to this unit.
Turn off this unit and reconnect the Yamaha iPod
universal dock to the DOCK terminal of this unit.
14
Try resetting your iPod.
Unknown iPod The iPod being used is not supported by
this unit.
Only iPod (Click and Wheel), iPod nano, and iPod
mini are supported.
iPod connected Your iPod is properly stationed in a
Yamaha iPod universal dock (such as
YDS-11, sold separately) connected to the
DOCK terminal of this unit, and the
connection between your iPod and this
unit is complete.
Disconnected Your iPod was removed from a Yamaha
iPod universal dock (such as YDS-11,
sold separately) connected to the DOCK
terminal of this unit.
Station your iPod back in a Yamaha iPod universal
dock (such as YDS-11, sold separately) connected to
the DOCK terminal of this unit.
14
Status message Cause Remedy
See
page
Searching... The Bluetooth receiver and the Bluetooth
component is in the middle of the pairing.
The Bluetooth receiver and the Bluetooth
component is in the middle of establishing
the connection.
Completed The paring is completed.
Canceled The paring is canceled.
BT connected The connection between the Bluetooth
Wireless Audio Receiver (such as YBA-
10, sold separately) and the Bluetooth
component is established.
Disconnected The Bluetooth component is disconnected
from the Bluetooth receiver (such as
YBA-10, sold separately).
No BT adapter The Bluetooth receiver is not connected to
the DOCK terminal.
Connect the Bluetooth Wireless Audio Receiver (such
as YBA-10, sold separately) to the DOCK terminal.
14
Problem Cause Remedy
See
page
Page view 47
1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 61 62

Comments to this Manuals

No comments