Yamaha RX-A710 Manual Page 112

  • Download
  • Add to my manuals
  • Print
  • Page
    / 141
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 111
En 112
FM/AM radio
USB and network
Problem Cause Remedy
FM radio reception is weak or noisy.
There is multi-path interference. Adjust the FM antenna height or orientation, or place it in a different location.
Your area is too far from the FM station transmitter.
Press MODE to select monaural FM radio reception (p.45).
Use an outdoor FM antenna commercially available. We recommend using a
sensitive multi-element antenna.
AM radio reception is weak or noisy.
The noises may be caused by fluorescent lamps, motors,
thermostats, or other electrical equipment.
It is difficult to completely eliminate noise. It may be reduced by using an outdoor
AM antenna commercially available.
Radio stations cannot be selected
automatically.
Your area is too far from the FM station transmitter.
Select the station manually (p.45).
Use an outdoor antenna commercially available. We recommend using a
sensitive multi-element antenna.
The AM radio signal is weak.
Adjust the AM antenna orientation.
Select the station manually (p.45).
Use an outdoor AM antenna commercially available. Connect it to the ANTENNA
(AM/GND) jack together with the supplied AM antenna.
AM radio stations cannot be registered
as presets.
“Auto Preset” has been used.
“Auto Preset” is for registering FM radio stations only. Register AM radio stations
manually (p.45).
Problem Cause Remedy
This unit does not detect the USB
device.
The USB cable connecting this unit and USB device is not
compliant with USB 2.0.
Use a USB cable compliant with USB 2.0.
Folders and files in the USB device
cannot be viewed.
The folder structure not supported by this unit is applied.
This unit supports folder hierarchies of up to 8 levels and up to 500 items (total of
files and subfolders) per folder. If necessary, modify the folder structure on your
USB device.
The network feature does not function.
The network parameters (IP address) is not obtained properly.
Enable the DHCP server function on your router and set “DHCP” in the “Setup”
menu to “On” on this unit (p.96). If you want to configure the network parameters
manually, make sure using an IP address which is not used by other network
devices in your network (p.96).
This unit does not detect the PC.
The media sharing setting is not correct.
Configure the sharing setting and select this unit as a device to which music
contents are shared (p.64).
Some security software installed on your PC is blocking the access
of this unit to your PC.
Check the settings of security software installed on your PC.
This unit and PC are not in the same network.
Check the network connections and the settings of your router to connect them to
the same network.
Page view 111
1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 140 141

Comments to this Manuals

No comments