Yamaha HTR-4063 Manual download pdf (Page 26)

En 26

CONNECTIONS

Set up the speaker parameters automatically (YPAO)

■

Message list

■ When a warning message appears before

measurement

■ Error message

NOTE

If the following messages appear, resolve the problems that have

occurred and carry out the measurement process again.

Connect MIC! The YPAO microphone is

not connected.

Connect the YPAO

microphone to the YPAO

MIC jack on the front

panel.

Unplug HP! The headphones are

connected.

Remove the headphones.

Memory Guard! The settings of this unit

are protected.

Set “Memory Guard” in

the Setup menu to “Off”

(☞p. 58).

E-1:FRONT SP The unit was not able to

find the front channel.

Check that the left and

right front speakers are

connected correctly.

E-2:SUR. SP The unit was only able to

find one of side of the

surround channels.

Check that the left and

right surround speakers

are connected correctly.

E-4:SBR->SBL Only one surround back

speaker is connected and

only the right side

surround back channel

sound is detected.

When only one surround

back speaker is

connected, connect to the

left side terminal on the

external amplifier.

E-5:NOISY The noise is too loud,

preventing accurate

measurements from

being taken.

Measure again in quiet

surroundings. Turn off any

devices in the room that

may be emitting noise, or

place them further away

from the YPAO

microphone.

When this message is

displayed, selecting

“Proceed” will allow you

to continue measuring.

However, we recommend

resolving the problem and

measuring again, as

continuing measurement

without doing so will not

give accurate results.

E-6:CHECK SUR. Even though surround

left and right speakers are

not connected, only the

surround back speakers

are connected.

When using surround back

speakers, connection of the

surround left/right

speakers is necessary.

E-7:NO MIC The YPAO microphone

has been removed.

While measuring, take

care not to touch the

YPAO microphone.

E-8:NO SIGNAL The YPAO microphone

could not distinguish a

test tone.

Check that the YPAO

microphone has been

installed correctly.

Check that each speaker

has been connected and

installed correctly.

The YPAO microphone

or the YPAO MIC jack

may be broken. Inquire at

the retailer where you

purchased this unit, or the

nearest Yamaha service

center.

E-9:CANCEL You have carried out an

operation that has

cancelled the measuring

process.

Carry out the measuring

process again. Do not

operate this unit by, for

example, adjusting the

volume.

E-10:INTERNAL An internal error has

occurred.

Carry out the measuring

process again. Contact a

Yamaha service center if

“E-10” appears again.

1 ... 25 26 27 ... 97

Comments to this Manuals

No comments