Yamaha DVX-S60 Owner's Manual download pdf (Page 28)

E-24

Using the sleep timer

The sleep timer automatically switches off the power after a preset time

has elapsed. The volume will gradually be reduced (faded-out) from 1-

minute before the unit turns off. There are 9 time periods available: 90, 80,

70, 60, 50, 40, 30, 20, and 10 minutes.

Press the SHIFT + 6 SLEEP buttons repeatedly to select the desired sleep

time. “SLEEP” appears on the display. After several seconds, the original

display returns and the brightness of the display reduces.

To check the remaining sleep time

Press the SHIFT + 6 SLEEP buttons once. After several seconds, the

original display returns.

To release the sleep timer while in operation

Press the SHIFT + SET/CLEAR buttons. The timer is also released if the

power is switched off.

TIMER OPERATION

(Using the remote control)

Using the timer

Set the time when the timer turns on and off, source to be used and volume

level. Timer operation will start with the selected source at the “on” time.

The power will be switched off at the “off” time.

The timer will function every day unless it is released.

Preparation

Note:

Make absolutely sure that the clock is set to the correct time before setting

the timer.

- Select the source for timer operation and prepare the source to be

used.

- If the selected source is the tuner, tune in to the desired band and

station.

- Adjust the volume level as desired.

Operation

1. Press the SHIFT + 7 TIMER buttons.

The previously set timer “on” time setting appears.

2. Press the SHIFT + 8 ADJUST buttons within 15 seconds.

3. Set the hour of the “on” time by pressing the TUNING – or + button,

then press the SHIFT + 8 ADJUST buttons.

Set the minute in the same way.

The timer “off” time setting appears.

4. Set the timer “off” time as described in step 3. “0” blinks.

5. While “0” is flashing, press the INPUT button to select the source to

be used.

6. Press the SHIFT + 8 ADJUST buttons.

The timer operation standby mode is activated. “0” remains lit.

7. Press the STANDBY/ON button to switch off the power.

- “0” disappears from the display when this system is turned into the

standby mode.

- To switch off the power during a timer-controlled operation, press the

STANDBY/ON button. The timer will be set in the standby mode.

To check the timer settings

Press the SHIFT + 7 TIMER buttons repeatedly. The timer settings are

displayed in the following order:

On time v Off time v Source

To change the settings, press the SHIFT + 7 TIMER buttons to select the

setting to be changed, then press the SHIFT + 8 ADJUST buttons to make

the display flash. Change the setting as explained above.

To release the timer

After turning the power on, press the SHIFT + 7 TIMER buttons, then press

the SHIFT + SET/CLEAR.

Note:

- If the SHIFT + SET/CLEAR buttons are pressed while the timer is

being set, the original display returns.

- The timer mode is released if a power failure occurs during timer

controlled operation.

- The timer may not operate if a power failure occurs during timer

operation standby mode.

OFF

A3-60U-E (02.7.26)a 02.8.8, 3:39 PM24

1 2 ... 23 24 25 26 27 28 29 30 31

Comments to this Manuals

No comments

Yamaha DVX-S60 Owner's Manual Page 28

Comments to this Manuals

Related products and manuals for AV receivers Yamaha DVX-S60