Yamaha RX-V473 Manual

Browse online or download Manual for Unknown Yamaha RX-V473. RX-V473/RX-V573/HTR-4065/HTR [no] User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 3
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
RX-V473/RX-V573
HTR-4065/HTR-5065
1
In case of error, see the
Troubleshooting
section
IMPORTANT NOTICE
Do not attempt to update your Yamaha receiver using any other data file except those provided directly from the
Yamaha website or through your network connection.
Follow the instructions carefully and do not attempt any other procedures not specified in the instructions provided by
Yamaha.
Improperly updated products may cause improper operation, and any parts or service required to restore proper
operation will not be covered under the Yamaha Limited Warranty.
FIRMWARE UPDATING PROCEDURE
SETUP ke
y
Requirement:
USB thumb drive, with enough free space to store over 25MB.
(File system with FAT16 or FAT32 format)
Firmware file provided by YAMAHA, “R0305-xxxx.bin”.
1
Prepare USB thumb drive for the update
Download the firmware, unzip and copy “R0305-xxxx.bin” into the root directory of the USB thumb drive.
Dra
g
& Dro
p
the file into USB thumb drive.
2
Power off the receiver (Standby mode)
3
Insert the USB thumb drive
USB port is located at the lower left corner of the front panel.
4
Enter the ADVANCED SETUP mode
While pressing the
STRAIGHT
key, press the
(power)
key and keep
STRAIGHT
key pressed until
“ ADVANCED SETUP ” appears on the front panel display.
Page view 0
1 2 3

Summary of Contents

Page 1 - FIRMWARE UPDATING PROCEDURE

RX-V473/RX-V573 HTR-4065/HTR-5065 1 In case of error, see the Troubleshooting section IMPORTANT NOTICE Do not attempt to update your Yamaha receiver

Page 2 - Caution

RX-V473/RX-V573 HTR-4065/HTR-5065 2 5 Select firmware update from the menu Press the PROGRAM key until “UPDATE...USB ” is displayed. USB port 6 Star

Page 3 - Troubleshooting

RX-V473/RX-V573 HTR-4065/HTR-5065 3 CASE 1 Error message appeared during the update Cause: For some reason, the receiver can’t read the firmware dat

Comments to this Manuals

No comments