CobraNetTM Interface Update Guide This update guide describes how to update the CobraNet Interface firmware for Yamaha CobraNet devices (ACU16-C, N
2. “Select Firmware Version” dialog box will appear after the progress bar is shown for a while as shown below. 3. Check that the firmware version
5. Click [OK] to close the pop-up window below and turn off the device. 6. Turn on the device again. Updating is now complete.
1. Preparation 1.1. System Requirements To update the CobraNet Interface following hardware and software are required. Computer Running Windows NT 4.
1.2. Connection When you use a cross cable, connect a PC LAN connector directly to the CobraNet device connector (PRIMARY or SECONDARY connector) as
1.3. Installation and Default Setting of CobraNet Discovery Follow the instructions below to install CobraNet Discovery and make the default setting
4. Select “Options” from the “View” menu. The “Options” dialog box appears. Select the network adapter used to connect the device you wish to update
8. The IP Address will appear in the “IP Address” column in the CobraNet Discovery main window once the IP Address of the device has been assigned. A
1.4. IP Address Manual Setting (if not updated properly by Automatic Setting) The manual setting is not required if it has been automatically assign
4. The dialog box for setting the IP Address will appear. 5. Enter the IP Address as shown below. Enter the same numbers of the PC’s IP Address
2. Updating Procedure 2.1. Checking Your Current Firmware Version Connect to the device you wish to update before turning on the device and then l
Comments to this Manuals