Yamaha YST-SW60 Owner's Manual download pdf (Page 9)

1 Set the VOLUME control to minimum.

2 Turn on the power supply to all the components.

3 Play any source and adjust the amplifier’s volume control

to the desired listening level.

4 Turn up the VOLUME control gradually to adjust the

volume balance between this unit and the main speakers.

5 Adjust the HIGH CUT control to the position where the

desired response can be obtained.

6 Set the PHASE switch to the position (NOM or REV)

where the optimum bass effect can be obtained.

Notes

•

Once the volume balance between this unit and the main

speakers is adjusted, you can adjust the volume of your

whole sound system by using only the amplifier’s volume

control.

•

For adjusting the VOLUME control, the HIGH CUT control

and the PHASE switch, refer to “FREQUENCY

CHARACTERISTICS” on the next page.

For effective adjustment of the HIGH CUT control

First set this control at about the main speakers’ rated

minimum reproduceable frequency. Then turn up the

VOLUME control gradually and set it at a level where you can

obtain a little more bass effect than when this unit is not used.

On the basis of this setting, if desired, adjust the VOLUME

control and the HIGH CUT control again.

* The main speakers’ minimum reproduceable frequency can

be looked up in the speakers’ catalog or owner’s manual.

ADJUSTING VOLUME

POWER HIGH CUT VOLUME

140 Hz

010

40 Hz

POWER HIGH CUT VOLUME

200 Hz

010

50 Hz

NOM REV

OUTPUT INPUT2 PHASE

TO SPEAKERS

INPUT1

FROM AMPLIFIER

Front panel

Rear panel

2 5 1, 4 2 5 1, 4

YST-SW120 YST-SW60

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Yamaha YST-SW60 Owner's Manual Page 9

Comments to this Manuals

Related products and manuals for Subwoofers Yamaha YST-SW60