Yamaha YAS-201 Owner's Manual download pdf (Page 13)

　

13

Remote control

Problem Cause Remedy

The sound bar cannot

be controlled using

the remote control.

The sound bar is out of the operating

range.

Use the remote control within the operating

range (p.8).

The batteries are weak. Replace with new batteries (p.8).

The remote control sensor of the

sound bar is exposed to direct sunlight

or strong lighting.

Adjust the lighting angle, or reposition the

sound bar.

The TV cannot be

controlled using the

TV remote control.

The remote control sensor of the TV is

blocked by the sound bar.

Use the TV Remote Repeater function (p.11) or

remove the stands of the sound bar so that the

TV remote control sensor is not blocked (p.6).

There may be any problem with the

TV or TV remote control.

Refer to the manuals of the TV.

The TV cannot be

controlled by using

the TV Remote

Repeater function.

The TV Remote Repeater function is

disabled.

Enable the TV Remote Repeater function (p.11).

The TV remote control does not

use infrared signals. (Some remote

controls may not work even if it uses

infrared signals.)

The TV Remote Repeater function cannot be

used in this case. Adjust the position of the

sound bar so that the remote control sensor

of the TV is not blocked by the sound bar and

use the TV remote control to operate the TV.

The sound bar and TV are too close

or too far from one another.

Move the sound bar to adjust the distance

between the TV Remote Repeater and TV

(remote control sensor) (p.11).

If necessary, remove or attach the stands of

the sound bar (p.6).

There is any obstacle (such as cables)

between the sound bar and TV.

Remove the obstacle between the sound bar

and TV.

The sound bar does

not learn TV remote

control operations.

The TV remote control key was not

held down long enough.

Hold down the key for more than 1 second

twice or three times (p.10).

The TV remote control does not

use infrared signals. (Some remote

controls may not work even if it uses

infrared signals.)

The TV remote control learning function

cannot be used in this case. Use the supplied

remote control to operate the sound bar.

The position where you operated the

TV remote control is not appropriate

Operate the TV remote control at the

appropriate position (p.10).

The batteries of the TV remote control

are weak.

Replace with new batteries.

The remote control sensor of the

sound bar is exposed to direct sunlight

or strong lighting.

Adjust the lighting angle, or reposition the

sound bar.

The transmission of the remote control

signal was disturbed by the TV screen

light.

Turn off the TV and perform the learning

operation again (p.10).

Sound is coming

from the TV when the

sound bar volume is

turned up with the TV

remote control.

(when TV remote

control learning

function is used)

Audio output is enabled on the TV. Change the TV setting to disable the TV

speaker output. If a setting to disable the

speaker output is not available on your TV, try

the following methods.

- Connect headphones to the headphone jack

on the TV.

- Set the TV volume to minimum.

The power of the

sound bar and of

the TV switch in the

opposite direction.

(For example, the TV

is turned off if the

sound bar is turned

on.)

(when TV remote

control learning

function is used)

The power of the TV was on when you

performed the learning operation.

Press the power key on the TV and

(power)

on the front panel of the sound bar to turn on

them and then press the power key on the TV

remote control to turn off them.

1 2 ... 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments