Yamaha AV-S7 Owner's Manual Page 26

  • Download
  • Add to my manuals
  • Print
  • Page
    / 29
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 25
E-22
USING THE AV-S7
STANDBY/ON
INPUT PROGRAM
Adjusting the center speaker volume
If desired, you can adjust the volume level of the center
speaker even if the volume is already set in “SPEAKER
BALANCE ADJUSTMENT” on page 19.
By continuously pressing the CENTER (+ or –) button,
the volume value changes continuously.
Notes
This adjustment can be made only when the digital
sound field program DOLBY PRO LOGIC or DOLBY
PRO LOGIC ENHANCED is selected.
Once the volume level is adjusted, the volume value
will be the same in all the digital sound field
programs mentioned above.
Adjusting the rear speaker volume
If desired, you can adjust the volume level of the rear
speakers even if the volume is already set in
“SPEAKER BALANCE ADJUSTMENT” on page 19.
By continuously pressing the REAR level (+ or –)
button, the volume value changes continuously.
Notes
This adjustment can be made only when the built-in
digital sound field processor is on.
Once the volume level is adjusted, the volume value
will be the same in all the digital sound field
programs.
Adjusting the subwoofer output volume
Adjust the subwoofer output volume to the desired level
by pressing the SUBWOOFER level (+ or –) button.
If you feel that the bass tone is insufficient, increase the
volume, or if you feel it is overly emphasized, reduce
the volume.
To finish listening to a source
1
Stop playing a source.
2 Press the VOLUME –” button to decrease the
volume to the minimum.
3 Press the STANDBY/ON button (or the POWER
button on the remote control transmitter) to switch
the system to standby mode.
POWER
VOLUME
TEST
D
E
BC
A
ENHANCED
CONCERTPROLOGIC
MONO MOVIESPORTS
OFF
DSP
CENTER
REAR
SUBWOOFER
INPUT
AMP
1/2
3
3
2
SUBWOOFER
REAR LEVEL
CENTER LEVEL
AV-S7(E)17-24 9/11/0 9:07 AM Page E-22
Page view 25
1 2 ... 21 22 23 24 25 26 27 28 29

Comments to this Manuals

No comments