Yamaha RX-V340 User Manual download pdf (Page 14)

■ Connecting the AM loop antenna

1 Set up the AM loop antenna, then connect it

to the terminals on this unit.

2 Press and hold the tab to insert the AM loop

antenna lead wires into the AM ANT and

GND terminals.

3 Orient the AM loop antenna for the best

reception.

Notes

• The AM loop antenna should be placed away from this unit.

• The AM loop antenna should always be connected, even if an

outdoor AM antenna is connected to this unit.

A properly installed outdoor antenna provides clearer

reception than an indoor one. If you experience poor

reception quality, an outdoor antenna may improve the

quality. Consult the nearest authorized YAMAHA

dealer or service center about the outdoor antennas.

FREQUENCY STEP switch

(General model only)

Because the inter-station frequency spacing differs in

different areas, set the FREQUENCY STEP switch

(located on the rear panel) according to the frequency

spacing in your area.

North, Central and South America: 100 kHz/10 kHz

Other areas: 50 kHz/9 kHz

Before setting this switch, disconnect the AC power

plug of this unit from the AC outlet.

Ground (GND terminal)

For maximum safety and minimum

interference, connect the antenna GND

terminal to a good earth ground. A good

earth ground is a metal stake driven into

moist earth.

Indoor FM

antenna

(included)

AM loop antenna

(included)

Connecting the antennas

Both AM and FM indoor antennas are included with this

unit. In general, these antennas should provide sufficient

signal strength.

Connect each antenna correctly to the designated

terminals.

CONNECTIONS

EO TUNER

ANT

GND

ANT

MONITOR

OUT

75Ω UNBAL.

50 kHz/ 9kHz

100 kHz/10kHz

FM/AM

FREQUENCY STEP

04V340R_09-18_EN(3.2.25).p65 03.2.25, 7:57 PM12

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 59 60

Comments to this Manuals

No comments

Yamaha RX-V340 User Manual Page 14

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Yamaha RX-V340