Yamaha RX-V495 Manual download pdf (Page 52)

NOTES ABOUT THE REMOTE CONTROL TRANSMITTER

Battery installation Remote control transmitter operation range

Notes

• There should be no large obstacles between the remote

control transmitter and the unit.

• If the remote control sensor is directly illuminated by strong

lighting (especially an inverter type of fluorescent lamp, etc.),

it might cause the remote control transmitter not to work

correctly. In this case, reposition the unit to avoid direct

lighting.

Battery replacement

If the remote control transmitter operates only when it is close

to the unit, the batteries are weak. Replace all batteries with

new ones.

Be sure to replace batteries within about two minutes. If it

takes longer than two minutes, the codes preset for the

remote control transmitter will return to the factory-set.

Notes

• Use only AAA, R03, UM-4 batteries for replacement.

• Be sure the battery polarity is correct. (See the illustration

inside the battery compartment.)

• Remove the batteries if the remote control transmitter will not

be used for an extended period of time.

• If the batteries have leaked, dispose of them immediately.

Avoid touching the leaked material or letting it come into

contact with clothing, etc. Clean the battery compartment

thoroughly before installing new batteries.

Within approximately

6 m (20 feet)

Remote control

sensor

01RX-V495-e/f-6 6/22/99, 1:33 PM52

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 64 65

No comments

Yamaha RX-V495 Manual Page 52