30
1 Set the selector dial of the remote controller to
“AMP/TUN”.
2
Set to the “
∞
” position.
3 Select main speakers A or B.
* Both speakers A and B can be selected.
4 Turn on the power.
5
Set to the “0” position.
6
Set to the “OFF ( )”.
7 Press the TEST key on the remote controller to enter
the test mode.
This procedure lets you adjust the sound output level balance between the main, center and rear speakers using the built-in test
tone generator. After the adjustments, the sound output level heard at the listening position will be the same from each speaker.
This is important for the best performance of the digital sound field processor, the Dolby Digital decoder, the Dolby Pro Logic
Surround decoder and the DTS decoder.
The adjustment of each speaker output level should be done at your listening position with the remote controller.
EXT. DEC
.
Comments to this Manuals