Yamaha CRW2100E Owner's Manual download pdf (Page 27)

Setup Procedures

! Connect the IDE cable.

Connect the 40-pin IDE cable to the secondary IDE connector on

the motherboard and to the IDE interface connector on the rear

panel of the CRW2100E drive. Be sure to plug in the cable so

that the colored line on the cable corresponds to pin #1 on the

right end of the connector.

Motherboard

IDE cable

Magnified IDE

connector

section

Colored line

Primary

(connector)

Secondary

(connector)

CSEL

SLAVE

MASTER

IDE

INTERFACE

CONNECTOR

DC INPUT

AUDIO OUT

DIGITAL ANALOG

RGL

• If an IDE cable has already been connected to the secondary

IDE connector, replace it with the IDE cable.

• If you wish to continue using the IDE device you just

removed, connect it to an available primary or secondary IDE

connector.

• When you connect two IDE devices to one IDE cable, be sure

to assign them master or slave uniquely.

n To make the best use of the performance of the CRW2100E drive,

Yamaha recommends you connect it as a sole secondary master.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 47 48

No comments

Yamaha CRW2100E Owner's Manual Page 27