1 MTX/XMV/EXi8/EXo8 Firmware Update Guide Thank you for choosing a Yamaha product. This guide explains how to update the MTX series, XMV series, and
10 Computer TCP/IP setting ( for device main) To update device main firmware, configure computer TCP/IP settings. If only a YDIF model is being u
11 Updating the device main firmware This section explains how to update the device main firmware. Use an Ethernet cable to connect your computer t
12 About Failsafe Mode During normal operation, software must be loaded from a flash memory drive during operations to use the Dante module integr
13 10. Check the detected device. 11. Click [Start]. A pop-up is displayed confirming that you wish to proceed. 12. Click [OK] to start the reco
2 Checking the version number ・ You may check the firmware version of the device itself from the "Device Information" dialog box of MTX
3 Preparing for the update You will need the following items ready to execute the update procedure. ● A Windows computer equipped with the follow
4 Update procedure sequence Update each firmware component in the following sequence. If you're using a YDIF model, execute the shaded steps.
5 Decompressing the downloaded file Decompress the downloaded "mtx_editorxxx_firmxxx.zip" (xxx is the version number). The installer and
6 Install the Dante Firmware Update Manager (for Dante) Before you update the Dante firmware, you must install the Dante Firmware Update Manager.
7 Computer TCP/IP setting (for Dante) To update Dante firmware, configure computer TCP/IP settings. 1. Start up MTX Editor. ・The “User Account
8 Updating the Dante firmware Described below are the procedures to update the Dante module firmware integrated in the device. Use an Ethernet cabl
9 7. Check the device to update. Check the version of the update files and the version number indicated in the device line. ・If the device is not in
Comments to this Manuals