Yamaha MY8-TD Owner's Manual download pdf (Page 7)

Installing an optional I/O card

1. Turn off the power to the DIO8 and remove the power

cord from the DIO8.

2. Loosen two screws as shown below and remove the

slot cover.

Keep the cover in a safe place for future use.

3. Align the edge of the card with the guide rail inside the

slot as shown below and insert the card into the slot.

Push in the card until the connector on the card is

securely plugged into the terminal inside the DIO8.

4. Fix the card by tightening the two screws.

5. Connect the power cord to the DIO8 and turn the

power on.

■

Speciﬁcations

[AP8AD]+[AP8DA] cards used

[MY8-AD]+[MY4-AD]+

[MY4-DA] cards used

[MY8-TD]+[MY8-AT]+[MY8-AE] cards used

Total 0 cards Up to a total of 8 cards

Total 1 card Up to 6 cards Up to the number of vacant DIO8 slots

Total 2 cards Up to 4 cards Up to the number of vacant DIO8 slots

Total 3 cards Up to 2 cards Up to the number of vacant DIO8 slots

Total 4 card Up to 1 card Up to the number of vacant DIO8 slots

Total 5 or more cards cannot be used ——

Important!

Before installing an optional I/O card, be sure to turn off the power to the DIO8 and remove the power cord from the

DIO8. Otherwise, you may be in danger of electrical shock, and/or the unit or the card may be damaged.

–

)

Caution:

Be sure to tighten the screws securely. Otherwise,

the card may not be appropriately grounded.

Guide rail

Sampling frequency (external sync) 39.69 kHz – 50.88 kHz

Power supply

USA and Canada : 120 V, 60 Hz

Others : 230 V, 50 Hz

Power consumption 70W

Dimensions (W

D) 480 mm

185.5 mm

411.6 mm

Weight 15.5 kg

Operating temperature 10 – 35˚C

Power cord length 1.5 m

Accessories Connection cable (68-pin, D-sub, half-pitch) x 2, Length: 3m

1 2 3 4 5 6 7 8 9

Comments to this Manuals

No comments

Yamaha MY8-TD Owner's Manual Page 7

Comments to this Manuals

Related products and manuals for Musical Equipment Yamaha MY8-TD