Yamaha XV17ASZ Service Manual download pdf (Page 72)

– 65 –

ENG

CRANKSHAFT AND CONNECTING RODS

WARNING

When a bolt is tightened more than the

specified angle, do not loosen them and

then retighten them.

Replace the bolt with a new one and per-

form the procedure again.

CAUTION:

• Do not use a torque wrench to tighten the

bolt to the specified angle.

• Tighten the bolt until it is at the specified

angle.

NOTE:

The angle between the corners of the connect-

ing rod bolts is 30°.

h. Remove the connecting rod and big end

bearings.

Refer to “REMOVING THE CONNECTING

RODS” in chapter 5.

(Manual No.: 4WM-28197-E0)

i. Measure the compressed Plastigauge

width e on each crankshaft pin.

If the crankshaft-pin-to-big-end-bearing

clearance is out of specification, select

replacement big end bearings.

▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 82 83

No comments

Yamaha XV17ASZ Service Manual Page 72